Installing new stereo

By gcope63
October 1, 2004 in Audio, Electronics & Software

Recommended Posts

gcope63

Posted October 1, 2004

I am upgrading my stereo and was wondering if there is an easy way to remove the bezel from around the factory stereo??

Thx

Gary

Wingnut

Posted October 1, 2004

Most of us start in the upper left hand corner, and just start pulling firmly, but carefully. It just snaps right off.

You may have to adjust your tilt up and/or down to get it off, but it's an easy task.

gcope63

Posted October 1, 2004

Author

Posted October 1, 2004

Thanks!!!!

Gary

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

Recently Browsing 0 members
- No registered users viewing this page.
Forum Statistics

250.4k
Total Topics

2.7m
Total Posts
Member Statistics

342,793
Total Members

8,960
Most Online

Newest Member
sqidget
Joined 19 hours ago
Who's Online 12 Members, 0 Anonymous, 1,241 Guests (See full list)
- revmanii
- Atomicgrl
- 81mmcat
- BCGM
- GAMark
- Flynlow
- KARNUT
- Coastie05
- truckguy82
- asilverblazer
- AndrewF
- Steve-2019

Latest Articles
Posts
- Travel Trailer 2024 2500 HD 6.6 Gas Engine ?
  
  By BCGM · Posted 12 minutes ago
  
  Thanks Fellas ! I still have questions so hope you fellas will bare with me !
- Remote Start Noise 2024 2500 HD Gas
  
  By BCGM · Posted 19 minutes ago
  
  Okay thank for letting me know that Byrds 8 They replaced the Starter think that was the issue . Well no that's not what it was ! At least I did not have to pay for it
- Travel Trailer 2024 2500 HD 6.6 Gas Engine ?
  
  By BCGM · Posted 21 minutes ago
  
  Here is our inside door sticker
- PPE Transmission Pan Install
  
  By GMC4Zee · Posted 1 hour ago
  
  Is this the pan everyone is talking about PPE Power 128051910 . this can be gotten from JEGS.
- Travel Trailer 2024 2500 HD 6.6 Gas Engine ?
  
  By Texas Gasser · Posted 1 hour ago
  
  My truck is a 2024 2500 LT crew cab with the 6.6 gas engine and 10 speed trans. It has a payload of 3578 lbs. We pull a 22' Grand Design 17MKE that has dry weight of 5006 lbs. and a gross weight of 6395 lbs. The trailer weighs about 5800 lbs. when loaded up with all the gear. I don't fill the water tank for travel as most of our trips are to state parks that are within a day's drive. Depending on the wind I get anywhere from 7.5 to 9 mpg. I do use a weight distribution hitch (WDH) and have no problems with sway or being pulled/pushed side to side by 18-wheelers passing by me. The trailer is about the same length of the truck so that helps a lot. I say that because we traded in our 33' Grand Design 2670 MK (7800 lbs. loaded with gear) and using the same WDH, it would get pulled side to side by big trucks passing by me. It was not bad, but you needed to stay alert and know when a big truck was pulling up beside you. I got about 7 to 8 mpg pulling that trailer. I normally drive about 65 to 67 mph when pulling. Overall, I love the payload capability of the truck as I doubt I will ever get close to its limit and I love the stability it offers over a half ton truck while pulling a trailer. I have just over 30000 miles on the truck and have not had any issues. We live in Texas where it is relatively flat, just windy.
GM-Trucks.com Clubs
- Black Truck Club
  
  Open Club · 612 members
- White Truck Club
  
  Open Club · 380 members
- Canadian Owners Club
  
  Open Club · 282 members
- Red Truck Club
  
  Open Club · 157 members
- diesel 3.0
  
  Open Club · 279 members
- Texas Owner's Group
  
  Open Club · 371 members
- NorthSky Blue Club
  
  Open Club · 118 members
- Midwest Owner's Group
  
  Open Club · 212 members
- 2015 Custom Sport Club
  
  Open Club · 5 members
- GM Snow Plowing Club HD
  
  Closed Club · 14 members
Popular Contributors
- Week
- Month
- Year
- All Time
1. 1
  
  KARNUT
  21
2. 2
  
  Atlas
  20
3. 3
  
  Grumpy Bear
  17
4. 4
  
  Jsdirt
  11
5. 5
  
  Chuck FB
  9
Show More