Jump to content

clicking noise coming from transfer case (i think)


Recommended Posts

Posted
When does it happen? Normal driving conditions? Any speed? Over bumps?

 

 

I hear just pulling away from a stop. the faster i go the louder it is. don't hear it in reverse though. kinda like a light clunking noise. my u-joints seem tight. no leakage from the transfer. could it be a bearing in that?

Posted

ok i have done some reading on here. could my problem be the slip joint? i also read about the blue transfer fluid. manybe change that.

 

Is the slip joint covered by gm? i have a 00.

Posted
check to make sure no one put zipties on your drive shaft. :):crackup:

 

This can happen! I had something on my driveshaft that would hit on every revolution causing a click... It took the service tech quite awhile to figure out where the noise was coming from!

Posted

went to dealer today and checked on the nickle yoke. they want 227.00 for it.

 

2 questions.

 

 

 

1. How can I make sure that this is what I need?



2. Where you can you buy factory parts cheaper?

 

 

Thanks in adavace

Posted

Well I found the part on gmpartsdirect.com for almost $90 cheaper then the stealer. But I would still like to figure out if I need it or not. What about greaseing the splines? What kind of grease goes on that?

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,754
    Total Members
    8,960
    Most Online
    scotthvac.net
    Newest Member
    scotthvac.net
    Joined
  • Who's Online   0 Members, 0 Anonymous, 542 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...