Gauges Stopped Working

[badger60]

Yesterday I headed out to go top off at the fuel station and I noticed that the seatbelt light was blinking, the tach didn't work, and the speedo didn't work. I started to go through the digital display and it wasn't reading the tranny temp, oil/fuel percentage, or anything. This kind of caught me off guard as I only have 22K on the truck and have never had this happen before. I just got back from a 90 mile trip from the track towing my 23ft towhauler that morning and this was later in the afternoon. I'm going to call the service rep at the dealership and see if I need to take it in but if anyone knows what may have caused this it would be greatly appreciated.

[mhenshaw]

Always check the fuses.

[badger60]

Always check the fuses.

 

 

That is the first thing I did. All were good and once I turned the truck off at the fuel station and let it sit for 15 minutes I turned it back on and everything was fine. Same with this morning when I drove it to work...everything was working properly. Just don't want this to turn around and bite me in the A$$ when the warranty runs out at 36K.

[thegeniusguy]

if you got warranty take it now. and tell them what happen.

[tbondu]

Sounds exactly like what happened to me yesterday after washing my truck. I'll keep an eye on these two threads. Hopefully somebody has found what the issue is.

[bilesZ71]

same thing happened to me while i was driving it, i pulled over and turned it off and then started it back up and all was fine it has never done it again and i'm at like 20k so not sure why it does it but your not the only one.