Level Kit

[quikdraw92]

OK i,m new to forums here today i just installed a 3" front and 2" rear level kit and the driver side front is lower than the passenger front, i have turned driver side torsion bar all the way in and turned passenger side all the way out and still 1/2" different it was an inch different but could only get half of it, also after taking it up the road i got a message to check tire pressure monitor system and tire light flashing anyone know what causes it so i dont have to take it in to get fixed

[RyanbabZ71]

As far as the tpms it sounds like you may have bumped something or something came loose. Recheck all your connections

[quikdraw92]

I have done that already it didn't pop on till i drove about 40 miles so when i got home i rotated my tires and check connections but still has message to have tpms serviced

[doodeediddledodindee]

did you try resetting the tpms? if you rotated your tires you have to relearn the system

[ruggedlife]

by any chance did you install new tires/wheels at the same time that dont have sensors in them? and did you measure the truck before you touched anything? you could have one of the keys clocked wrong, did one go in a lot easier than the other? if you measured before you would have a better idea, but drive side almost always sits half an inch lower than passanger side, plus one torsion bar could be more worn than the other

[AEB]

did you try resetting the tpms? if you rotated your tires you have to relearn the system

 

x2