Jump to content

Passenger Temp resets to LO each time started

y7eah

By y7eah
in Troubleshooting & Recalls

Recommended Posts

y7eah Enthusiast

y7eah

Posted
Posted

I have a 2017 Silverado with the Auto Climate and I just noticed that when the passenger temp isn't sync'ed the passenger side always resets to LO whenever the truck is restarted. It only seems to happen if you have Auto mode enabled. If temps are sync'ed then they operate as expected. The 2016 I had previously did not do this.. seems like maybe a programming issue.

 

Anyone with a 16 or 17 have similar behavior? Trying to figure out if it's worth a trip to the dealer.

  • 2 weeks later...
  • 2 weeks later...
y7eah Enthusiast

y7eah

Posted
  • Author
Posted

I haven't had time to take it in yet. Can anyone else with a 2017 chime in on this and confirm that their passenger side doesn't reset to lo every time it's restarted? The 2016 that I had previously didn't do this. I can't imagine that it's intended behavior.

Dnt Senior Enthusiast

Dnt

Posted
Posted

My 2016 always goes back to the last setting it was on when it was turned off. I do not believe that your Climate Control system is operating as designed.

You probably have a virus "woolly worm" in your computer. (Onstar=where they watch and listen in to everything you do while driving or even outside around the truck) If you ever want to be President of the United States and want a smooth campaign without accusations of Locker Room Talk you need to be very careful what you say around your truck.....(you were grabbing what?) hahahahaha

y7eah Enthusiast

y7eah

Posted
  • Author
Posted

Just got the truck back today, dealer performed a HVAC System Control Module update. Passenger temp is now retained after shutdown.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • Grumpy Bear
      Sugar Bears 2015 GMC Terrain SLE-2 2.4 AWD

      By Grumpy Bear · Posted

      287,500 Mile Service   8/13/2026   Reset Fuel Trims   Since the work done in the previous post there was a good improvement in response in all areas except right after a fill up where the LTFT would go -20%+ for about four miles while the STFT was near neutral. Before the work they both went very negative for a few miles after a fill up but act normal thereafter.    We did a systems check of the vapor recovery system for functionality and ability to hold a vacuum. That checked out fine. But this doesn't mean the charcoal canister is dead in the water. Testing that is next up. For now the reset of the fuel trims.    I intentionally shorted the fill exactly two gallons to eliminate any chance of filling the canister. On start up the trims were behaving normally until I got up and rolling where the LTFT went -10 / -11%% but the short was + 2 to 0%. Within a mile the the STFT offset the LTFT and by 2 miles they were neutral. HUGE improvement but still not hunky-dory.    I'll watch them for a few days. Perhaps another tank where I will fill completely to 'first click' and compare. Meanwhile on the hunt for a new canister and I'll toss another purge value at it for good measure. Pending the outcome of the canister test that is. Progress of any kind is welcome.    Fuel economy improvement with bringing hole #3 back to the living was a noticeable bump to the positive. Even on the few miles I drove after the refill I already see another bump up by the trims reset.     She's purring like a kitten with a warm bowl of milk.     
    • OnTheReel
      Post your UOA, (used oil analysis) here

      By OnTheReel · Posted

      Yeah, shame I can’t really get that filter easily anymore. Running a PureOne. Your fave!    TAN would be neat to see. Confirmation I ran it too long probably. 🤣
    • superdave160
      Roll up bed cover experiences

      By superdave160 · Posted

      My son and I both bought new trucks in 2017. Both of us immediately put Truck Covers USA American Roll Covers on our trucks. My son still has his truck and it never sees the inside of a garage. We live in Alabama, so not much snow. My truck was my daily driver and was in the garage when I wasn't driving it or at work. No issues with either cover even after almost 9 years. About a year ago I sold my truck to my brother and bought a 2025 Silverado 2500. The second thing that I put on that truck was a new Truck Covers USA cover. They are very well made and have a very positive locking system. I looked at a Retrax and my concern was the way that the cover locked to the rail. BTW, the first thing I put on the new truck was step bars. Those new trucks are high!
    • superdave160
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By superdave160 · Posted

      The Allison 10 speed torque converter doesn't "lock up" like the previous transmissions. It has 4 operational modes; open, slip, transition from open to slip; transition from slip to open. I have an Edge CTS3 monitor and I monitor transmission torque converter slip. Step on the gas and you get a little slip. Take your foot off the gas and you get a little negative slip. I have not found a way to display the torque converter mode beyond that. My Edge CTS3 also displays something that our trucks should already display, the current gear. I also monitor throttle body position and engine load. If I see the engine load getting too high, I'll manually drop a gear.
    • Grumpy Bear
      Post your UOA, (used oil analysis) here

      By Grumpy Bear · Posted

      Nice result. Your filter is working well  I'd have like to have seen the acid number for this sample. Curious type that I am. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...