Propellor to transfer case

[Reis Taylor]

I blew up my rear differential, pulled the axles and the differential all out as one unit.

I had forgotten to do any form of a reference mark in regards to the propeller shaft so when I replace the rear differential axles and all as well as pulling out the propeller shaft I had no way of referencing the propeller shaft to the new rear differential that I installed. And so I have no idea on how to align it back up again. What can I do to align it properly?

[Jsdirt]

It's pretty simple. Install everything and go for a drive. Feel a vibration at 40-70 MPH? Unbolt the driveshaft again, and turn it 180°.

 

It's not mission critical that it goes back in the exact same phase as factory, but it can be annoying if there's a slight vibration present.