Jump to content

Gutting your cat


Recommended Posts

Posted

Just wonderin if anyone has gutted their catalytic converters? Im thinkin that there might be to much backpressure using the y setup into a single muffler. And, i dont want to go true duals mainly b/c of the money just yet. Was thinkin maybe if you gutted your catalytic verters and put a free flowin muffler on there, the y setup might not be to badly clogged up. I didn't wanna take the cats completely off b/c of the o2 sims. would guttin them cause any problems either? well,

any feed back would be appreciated about this topic

thanks guys

Posted

Ummm i dont exactly think that is a good idea. I have heard a few trucks that have had them gutted and it sounds like absolute $hit. It has a nasty hollow noise and makes your truck louder than it was originally with that nasty noise. i wouldnt reccommend it but thats just my .02. id recommend buyin a high flow cat.

Posted

I would not recommend it unless you have some major power adder. I noticed a loss in low end torque after cleaning mine out with my supercharged application & I would hate to see how a n/a truck would react. My truck actually runs worse in by-pass mode but in supercharged mode it screams.

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • Yes, and also pulling heavy trailers or a large camper up steep grades as well as descending grades such as the more rustic off road camping locations and using engine braking with that low gearing as well as soft ground can just suck the power . I realize pickups these days tend to have an over all lower first gear ratio compared to automatic transmission pickups from years back so that has helped a lot in its ability in high range but there comes a point if in four wheel drive the torque runs out at the wheels, certainly with a gas engine. They don't put two speed transfer cases on pickups for a cool factor, they have a function if one needs that massive torque to the wheels that high range can't deliver. 
    • Notes 7/18/2026   3,400 miles on this batch of Mobil 1 Euro 5W40 since the GDI pump replacement. Alcohol runs very clean when ring seal is tight and the sump isn't getting hosed with fuel. Checked oil level at fill up today as is my practice and grabbed a white Kleenex to look at the color. What color?  I was going to change it but.....  
    • 4 low is really nice on steep boat ramps. 
    • Interesting, I suspect I would have fueled up in Lee Vining as the day prior I would have filled up either in Laughlin or near there and maybe again before I entered Death Valley and once out the other side late that evening as I kept on driving into the night up near Lee Vining. Next morning I most likely fueled up in LV before heading over Tioga Pass into ( as I refer to it as "Yose .... Mite" 😁 ). And again that was 19 years ago but the price then must not have jumped out at me like the 5 bill a gallon theme of nutty cult hippy country Big Sir or head so far up their rear Aspen. I'd be curious to know where the highest prices are in the lower 48, I probably would not be far off to guess somewhere in Cali forn ie. Coldfoot and Prudhoe bay may have those prices beat but that is a whole other world up there and when prices are more normal elsewhere that is about what they can be up there I believe in no mans land. Anyway interesting that the 395 corridor is hosing people and the thing is, its tourist season and its not like there are a lot of competition options when driving up that highway from what I could see. Yup, big ole Boaterhomes and various other RV's ahead and behind me at the Yosemite entrance gate and they have to get their fuel somewhere.  
    • Those can be high, as well as the big California cities. The ones that will pop your eyes out are the 395 corridor on the Eastern side of the Sierra Nevadas. Lee Vining, $7.19 for regular and $8.89 for diesel is what the Google said right now.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...