Jump to content
  • Sign up for FREE! Become a GM-Trucks.com Member Today!

    In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs. From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. 

Recommended Posts

Hello I'm new to the forums so bare with me... 

I have a 2000 chevy silverado 2500hd

6.0 gas np246 transfer case 

 

I bought this truck a while back. Never had the issue of using 4wd until this month. 

 

My actuator was not working so I ordered a new one...

I ran into a few problems.. 

My original actuator was a 4pin. But someone cut the cables and added a two pin plug. The trucks original harness is a 2pin. 

 

The actuator i bought, is a two pin. But the problem is my shaft does not aline with my actuator in 2hi. 

I shifted the transfer case shaft to line up with my actuator. But that doesn't work because it stays on 4hi or 4lo...

 

Is there any way or a place where I can buy a 2pin plug, 6pin actuator? Or point me in the right direction? Thank you.!

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.