Jump to content

Recommended Posts

Posted

So I have a 2003 chevy 1500 with about 293000 miles on it. I have been having voltages drops while driving. The voltage will drop only in the cab to almost 9 volts at times. The abs light l, parking brake light and sometimes the airbag and security light will come on too. This happens when the hvac fan speed is above 1 sometime it even happens on speed one also. It also happens if the music is turned up or if any other accessories are on in the cab. The voltage is normal everywhere else on the truck the only voltage drop is in the cab. I located all of the in cab grounds and cleaned them. I have tried swaping the dash cluster, the hvac module and it has a new transfer case control module. I have also taken apart and checked all the connections on the abs module. It also have a new fan restor. I've tried unplugging molutiply different accessories like the fan motor etc and nothing fixed it. My mechanic friend hooked up his fancy snap on scanner and determined it was not the ecu. I have also tryed putting different alternators on it and nothing worked. When it started I had no after market accessories in the cab. I can't seem to find where the voltage drop is coming from. If anyone has ran into this let me know

Posted (edited)

Warning lights are coming on because of the low voltage. Sounds like your alternator and/or battery is going bad.

 

The alternator should keep voltage above 12 volts while running, the battery stores the voltage for when the alternator is producing power. 

 

Problem 1 is the alternator isn't keeping voltage up while running. 

 

Problem 2 is the battery isn't keeping the 12 volts up, while the alternator is out - unless you are running it long enough that any available voltage in the battery gets depleted.

Edited by asilverblazer
Posted

I've already tryed putting in a new alternator and battery and neither worked. But everywhere else on the truck under the hood and everywhere else is getting the correct voltage. The ecm is also getting the correct voltage. The voltage starts dropping only in the cab and does not effect anything else on the truck, the head lights don't dim or anything like that

Posted

So I must not have read the original post well enough... Sounds like you've isolated it to the cab and checked grounds. I would start trying to isolate circuits if possible. Also check the wire harness where it goes into the cab at the firewall next to the brake booster. Wouldn't hurt to check the BCM either. 

 

Weather conditions make it worse? Water could be leaking into something...

Posted
2 hours ago, asilverblazer said:

So I must not have read the original post well enough... Sounds like you've isolated it to the cab and checked grounds. I would start trying to isolate circuits if possible. Also check the wire harness where it goes into the cab at the firewall next to the brake booster. Wouldn't hurt to check the BCM either. 

 

Weather conditions make it worse? Water could be leaking into something...

I had also looked at the wiring harness going into the cab and all looked good and it doesn't change weather it's cold or hot or raining or sunny 

Posted

I'm running out of ideas... when it is acting up pull fuses to see if what circuit is causing it or are immune to it. Make a detailed note of what circuits are dropping voltage and are not. Track all the good circuits and bad circuits on a wiring diagram to see what are grouped together or other common points.

 

What happens if you shut the truck off and restart it?

 

You checked all the cab grounds, what about cab to chassis?

Posted
1 hour ago, asilverblazer said:

I'm running out of ideas... when it is acting up pull fuses to see if what circuit is causing it or are immune to it. Make a detailed note of what circuits are dropping voltage and are not. Track all the good circuits and bad circuits on a wiring diagram to see what are grouped together or other common points.

 

What happens if you shut the truck off and restart it?

 

You checked all the cab grounds, what about cab to chassis?

I will try pulling the fuses and isolating the circuits. If I turn the truck off and restart it still does it. And yes I checked that one and all the other ones under the hood and in the cab and on the frame

 

1 hour ago, asilverblazer said:

I'm running out of ideas... when it is acting up pull fuses to see if what circuit is causing it or are immune to it. Make a detailed note of what circuits are dropping voltage and are not. Track all the good circuits and bad circuits on a wiring diagram to see what are grouped together or other common points.

 

What happens if you shut the truck off and restart it?

 

You checked all the cab grounds, what about cab to chassis?

Also someone recommended I try running a ground strait from the battery negative to the dash what do you think about that

Posted
15 hours ago, Wyatt Tankersley said:

Also someone recommended I try running a ground strait from the battery negative to the dash what do you think about that

For sure, cables can rot out inside the insulation and you can't see it.

Posted
On 11/4/2022 at 8:40 AM, asilverblazer said:

For sure, cables can rot out inside the insulation and you can't see it.

It's fixed!! I ran a ground wire from the dash to the frame everything works perfect again

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,881
    Total Members
    8,960
    Most Online
    tararebecca
    Newest Member
    tararebecca
    Joined
  • Who's Online   2 Members, 0 Anonymous, 445 Guests (See full list)

  • Latest Articles

  • Posts

    • I agree, simplicity and reliability matter more as vehicles get more complicated. A V8 work truck option with fewer electronic features and a stronger warranty would definitely appeal to a lot of buyers who use their trucks for real work. Customizing it with trusted outfitters is often the best way to get exactly what you need
    • I’ve heard similar complaints from newer vehicles where the factory “premium” systems don’t always live up to expectations. A good installer should be able to improve the sound without turning it into a bass-heavy setup. I’d look into upgrading the front speakers, adding a quality DSP amplifier, and possibly improving sound deadening first—those changes usually make a much bigger difference than just adding a subwoofer. Hopefully someone local can recommend a reputable installer in the Las Vegas/St. George area.
    • Do you remember that Harley Davidson was more successful (solvent) when it produced about 60% of the market demand (by design) and forced wait times of up to three years? Even when your turn came around it was, "Take what we are giving you or move to the back of the line and start over". HUGE markup's were 'normalized' and dealer killed. 40% markup and no floor plan? What's not to love? Greed will kill them yet. They have surplus production and customer base is tanking. And still they think nosebleed pricing will work.  
    • The engine was done as part of the 6.2 recall?   You'd have to see if your VIN also has the 6.2 engine special coverage on it.  Coverage number is N252494003.  If you have this, your engine is covered under this and NOT the GM replacement part engine warranty which is 3yr/100k from the date of install.  The 3yr/100k mi warranty is in effect for non warranty purchases.     This is not any different if it was replaced under warranty without a recall or special coverage.  So if you had a 5.3 and it popped at 3 years in at 50,000mi during the 5yr/60k powertrain, the replacement engine would not get the 3yr/100k, and instead gets the remainder of the 5yr/60k as coverage.     So N252494003 gives 10 years or 150,000mi of coverage, which ever comes first, starting at the vehicle in service date.  So if your in service date is 01/01/2022, N252494003 gives you special coverage of the engine until 01/01/2032 or 150,000mi, whichever comes first.  So if your start date was 01/01/2022, you'd have left 5 years and 4 months (lets round to august 1st), or 62,000mi left of coverage.   So you need to know your in service date to know how much coverage is left.  
    • Okiee dokie there bud, way to take things to the extreme.   I guess you missed the whole point and take things way to serious. I installed different EV6 style injectors that just so happen to be larger in my car running the same LQ4 engine and with a better spray pattern than the stock style injectors and I noticed no difference in the idle quality. Kinda was my round about way of saying that even if you put the same size but better style injectors in your truck, you will likely see the same thing.    I'm sure you're great to have conversations with in person if that's how you act through a keyboard. One little things sets you off and now I guess my dick is all up in your face.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...