Low Washer Fluid Sensor

JCedar · January 30, 2005

Hey everyone,

I believe the sensor for my washer fluid is shot, the low washer fluid light keeps comming on but the reservoir is full. I just finished taking apart the electrical connection and cleaned it, it looked very clean but I figured I would give it a shot... light still comes on!!

My question is this.... does the sensor pop off, or unscrew??? Any suggestions on this?? part #'s or what not??

AirForceAngler · January 30, 2005

I believe you have to change the whole reservior, the sensor does not come out.

JCedar · January 30, 2005

ahhhhhh hahaha, guess I shoulda figured that. What a pain in the A**!!!! Oh well I guess it's not that expensive eh. Thanks for the info TahoeMike.

hvac1000 · January 30, 2005

Black electrical tape over the light works also.

99-2door · January 30, 2005

Black electrical tape over the light works also.

<{POST_SNAPBACK}>

Yeah, nice suggestion

Except that is also where every other message pops up including service engine soon.

WyRam · January 30, 2005

Black electrical tape over the light works also.

<{POST_SNAPBACK}>

Unplug the connector.........

JCedar · January 30, 2005

I am gonna go to the stealer this week and see how much I can get one for. I read the other posts about the tanks leaking and some ppl saying they are only around 25 bucks?? I suppose I could take my beer money for the week and spend it on the washer fluid tank instead...