This landing is worse than most. Patchy blacktop with washouts, soft gravel/sand at bottom that washes out with every heavy rain. I tell everyone to put it in 4WD. A lot of them think they can pull out their trailer in 2WD. They end up digging a hole and then putting it in 4WD. The lake is a pristine lake and has a lot of money on it. There are several wake boats and lot of large tritoons. The people with the money don't want it improved because they don't want more traffic.
Boat Landing 1.jfif
Boat Landing 2.jfif
Boat Landing 3.jfif
How wide are your rims?
Toyo specs 8.5-10.0-11.0 inches. My thought would be rim might be pulling the tire inwards creating a center that is more pronounced.
I also noticed that the spec sheet says max 65psi. So you could be right lowering the pressure to ~40 psi.
It get absolutely nothing. No chimes, no dash lights, it won’t crank. It’s completely dead outside of the obd2 port which is throwing no codes. I’m wondering outside of a rusty ground somewhere if it could be a connection on one of the fuse blocks? I would not be surprised if water could get under the main panel under the hood on the drivers side.
Nothing comes up when I run my scanner on it. It’s hasp power but it’s not wanting to pull any data. I’ll check the ground connections they very well could have some rust I need to clean up to make the connection.
I am having a similar issue with my 2016 Denali HD. Right rear tail lights do not work. Have replaced the the bulbs / rear wiring harness / unhooked the batteries (touching the unhooked battery cables together afterwards) for 30 minutes. Would appreciate any insights
Recommended Posts
Archived
This topic is now archived and is closed to further replies.