New Trans Tem Gauge Going In

[tyhuck]

Im going to be putting in a factory trand temp gauge into my cluster and I have all the parts gathered except the cluster face. Ive found a fw options, but I need some opinions.

 

I could go with this one, http://cgi.ebay.com/ebaymotors/ws/eBayISAP...e=STRK:MEWAX:IT . Its nice and cheap which is great for a persn like me. But, the speed is only marked out in 10mph increments. I would kinda like to have it marked off at least in 5mph increments because most speed limits that arent 70mph are in 5's around here (35, 45, 55, 65).

 

There is also this one, http://cgi.ebay.com/ebaymotors/06-07-CHEVY...=item5642eae54e , but its quite a bit more than I was hoping to pay.

 

Then I found this one, http://cgi.ebay.com/ebaymotors/ws/eBayISAP...e=STRK:MEWAX:IT , its a little cheaper than the second one, and its the closest one to a stock face that I found. But, it has a redline section on the tach and my truck doesnt, so I am not sure if this is the right setup for my truck.

 

 

So, what would you do? I want it to look as stock as possible, which is why Im going this route and not with an external guge like an Autometer. And, I want it to be as cheap as possible, which is why Im not gonna go with something like a ScanGauge or anything. Give me your opinions on what you would do given the the options above.

 

 

P.S.

 

If anyone has upgraded their cluster face and would concider selling their factory face fairly cheap, PM me and hopefully we can make a deal.

[Stevens03]

I like the 3rd one

[tyhuck]

I like that one too, but because it has the redline area on the tach, Im wondering what engine it was intended for, and if that would change any of the warning lights placements.

 

I just dont understand why those are so much more expensive than the factory Escalade face. It seeems like the Escalade stuff would be more expensive.