Jump to content

New TPMS Kent Moore tool will not read them


Recommended Posts

Brand New TPMS sensors. I use the DIC and go into TPMS program mode. I hold the tool near the valve steam and it will not find the new TPMS. The new sensors are P/N: 13581558. Is there something I'm missing here?

Link to comment
Share on other sites

Do you have the EL-50448 orange tool? Did you hit the button? Battery in the tool? GM sensors?

The dealership is the one with the tool. They tried both the orange and the larger black Kent Moore tools. As listed above the sensor P/N is 13581558...and yes they are factory sensors.

Link to comment
Share on other sites

Using the large gray Kent More tool you should be able to wake up each sensor and read the s/n and pressure. Even just laying on a bench. If not then the tool or sensors are bad. It will do this independent of vehicle status. Unlike the orange tool, this tool is also a diagnostic tool.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    246k
    Total Topics
    2.6m
    Total Posts
  • Member Statistics

    333,451
    Total Members
    8,960
    Most Online
    MRDEE
    Newest Member
    MRDEE
    Joined
  • Who's Online   2 Members, 0 Anonymous, 615 Guests (See full list)



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.