2.5" RC Level & 1.5" Body Lift Fitting 35x12.5r20 on a -24

[TubesteakBoogie]

On 6/1/2017 at 10:32 AM, njk4o5 said:

yeah I gained about 1" per side. i didn't take too many pics because i was trying to get it done before it got dark. you can see where i cut so i could bend the tab out and cut some more inside and then hammer it all back in. very simple took about 30mins per side

 

Are you able to repost these pics? I'm looking to norcal but havent found much useful info/pics

[dangav]

Anybody else find a useful post about the NorCal mod? Installed a 2.5 rc lift and 20x10 mayhem warriors with -25 offset on 275/60/20. I took off the mud flaps and still have some rub but not as bad. Debating between NorCal mod or 1.5 Zone body lift to clear the rubbing.

[Brandon Scott]

On 6/17/2019 at 1:24 AM, dangav said:

Anybody else find a useful post about the NorCal mod? Installed a 2.5 rc lift and 20x10 mayhem warriors with -25 offset on 275/60/20. I took off the mud flaps and still have some rub but not as bad. Debating between NorCal mod or 1.5 Zone body lift to clear the rubbing.

 

[Brandon Scott]

[dangav]

9 minutes ago, Brandon Scott said:

Thanks! I’m still debating on whether to NorCal or zone body lift. Did you end up heating and bending the fender trim or just cut a section off? I kinda wanted to keep my mudlflaps on so might go with the zone body lift.

[Brandon Scott]

3 hours ago, dangav said:

Thanks! I’m still debating on whether to NorCal or zone body lift. Did you end up heating and bending the fender trim or just cut a section off? I kinda wanted to keep my mudlflaps on so might go with the zone body lift.

I had to cut 4 or 5 in off you can see it in the pic above