Jump to content

Recommended Posts

Posted

We’ll never know what the issue is, as they ended up replacing the whole transmission.

Thus far it seems to be fine judging by the much lower temperatures (and much slower climbing) driving around town. Will hook up the boat soon and see what happens.


Sent from my iPhone using Tapatalk

  • 2 weeks later...
Posted

And today GM called me (?!) asking for an update, because they apparently have no clue what is going on and were not aware I’ve had the truck back since beginning of last week.


Sent from my iPhone using Tapatalk

  • 2 years later...
Posted

mine did the same this past weekend was on freeway going 70 and sudenly no accelerator pedal and message on dash saying “transmission hot idle engine “ so i pull over and let idle but cant check temperature so eventualy i drive slow off fwy in protect mode and turn engine off and wait 30 minutes and finaly temperature shows 270 degrees  my trans thermostat was stuck closed. only 73k miles and ever since them my transmission not the same my first gear is weak and has no torque when taking off from a stop 

Posted

GM quietly admitted their mistake with the original automatic transmission by-pass valve (thermostat) in 2014-2018 gas trucks. A while back, they replaced the part we all have from the factory, and replaced it with a part that looks identical, but that opens to send fluid to the cooler at a much lower temperature. 
 

I did try the “flip the pill” method, which was dead easy, but in my haste to complete the job, I neglected to press the c-clip into its channel fully. Ended up with a few litres of ATF coating my garage floor! In my fury at myself for missing such a simple thing, I got more angry at GM. So, I googled a bit and found the new part (86774933), which my local dealer had in stock. 

 

For the cost of a $100 part and minor effort to install, the truck now operates at safe temperatures all the time. Before, the ATF heated to around 195-200 just driving to work (half hour on hilly roads). With the new by-pass, it never gets above 150-155, even during a recent 8-hour drive through mountain passes here in northern BC, fully loaded and - because of 35 inch tires - constantly gearing down early on even small hills, not to mention the many 1-6 km long hills. 
 

As any ATF fluid temp/tranny longevity chart shows, fluid this cool prolongs the life of the transmission by app. 40,000 miles. So far, the best thing I’ve done to the truck (2015 AT new to me in March this year). 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,938
    Total Members
    8,960
    Most Online
    C. Hart
    Newest Member
    C. Hart
    Joined
  • Who's Online   3 Members, 0 Anonymous, 525 Guests (See full list)


  • Latest Articles

  • Posts

    • 287,500 Mile Service   8/13/2026   Reset Fuel Trims   Since the work done in the previous post there was a good improvement in response in all areas except right after a fill up where the LTFT would go -20%+ for about four miles while the STFT was near neutral. Before the work they both went very negative for a few miles after a fill up but act normal thereafter.    We did a systems check of the vapor recovery system for functionality and ability to hold a vacuum. That checked out fine. But this doesn't mean the charcoal canister is dead in the water. Testing that is next up. For now the reset of the fuel trims.    I intentionally shorted the fill exactly two gallons to eliminate any chance of filling the canister. On start up the trims were behaving normally until I got up and rolling where the LTFT went -10 / -11%% but the short was + 2 to 0%. Within a mile the the STFT offset the LTFT and by 2 miles they were neutral. HUGE improvement but still not hunky-dory.    I'll watch them for a few days. Perhaps another tank where I will fill completely to 'first click' and compare. Meanwhile on the hunt for a new canister and I'll toss another purge value at it for good measure. Pending the outcome of the canister test that is. Progress of any kind is welcome.    Fuel economy improvement with bringing hole #3 back to the living was a noticeable bump to the positive. Even on the few miles I drove after the refill I already see another bump up by the trims reset.     She's purring like a kitten with a warm bowl of milk.    BTW, adding 50 rpm to the idle took the majority of the negative timing out on cold start up and leaned the cold idle. No longer burbles in the cat. What a dumb way to heat a cat.      
    • Yeah, shame I can’t really get that filter easily anymore. Running a PureOne. Your fave!    TAN would be neat to see. Confirmation I ran it too long probably. 🤣
    • My son and I both bought new trucks in 2017. Both of us immediately put Truck Covers USA American Roll Covers on our trucks. My son still has his truck and it never sees the inside of a garage. We live in Alabama, so not much snow. My truck was my daily driver and was in the garage when I wasn't driving it or at work. No issues with either cover even after almost 9 years. About a year ago I sold my truck to my brother and bought a 2025 Silverado 2500. The second thing that I put on that truck was a new Truck Covers USA cover. They are very well made and have a very positive locking system. I looked at a Retrax and my concern was the way that the cover locked to the rail. BTW, the first thing I put on the new truck was step bars. Those new trucks are high!
    • The Allison 10 speed torque converter doesn't "lock up" like the previous transmissions. It has 4 operational modes; open, slip, transition from open to slip; transition from slip to open. I have an Edge CTS3 monitor and I monitor transmission torque converter slip. Step on the gas and you get a little slip. Take your foot off the gas and you get a little negative slip. I have not found a way to display the torque converter mode beyond that. My Edge CTS3 also displays something that our trucks should already display, the current gear. I also monitor throttle body position and engine load. If I see the engine load getting too high, I'll manually drop a gear.
    • Nice result. Your filter is working well  I'd have like to have seen the acid number for this sample. Curious type that I am. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...