2020 3500 accesories

[John Olson]

I got my new Dually just before christmas has anyone been able to locate any kind of aftermarket acc yet. I am really looking for a winch mount for the front with the grill gaurd. Westin has one in the development but I was hoping to get one soon

[mkeddie]

Not much available for the 2020 hd yet as far as aftermarket accessories go

Sent from my Moto Z (2) using Tapatalk

[SkidooSteve12]

This thread shows a new Fab Fours Vengeance bumper and pre-runner guard.

 

Doesn't look like they have a winch mount available yet. Best to contact them and ask.

https://fabfours.com/product/chevy-2500-3500-vengeance-front-bumper/

 

 

 

 

[OkieDavid]

I came into the forum to ask this question.  I don't have an AT4 yet, but am considering it for my next truck.  With the Ford Tremor 250 having an available factory warn winch and of course the Ram 2500 Power Wagon having a standard winch, I would have expected GM to offer it as an option.  I really like my current 2017 GMC 1500 AT, and my prior truck was a 2014 GMC 1500 AT, but I'm really disappointed that GM doesn't offer a factory winch and I'm wanting to move up to the 2500's payload.  I'm probably not in the market for a while yet so there's time for an aftermarket solution, but you would think with an off-road oriented truck, they would have benchmarked the competition better.  

[Ryan Wineinger]

Not sure if you ever

On 1/23/2020 at 6:05 PM, John Olson said:

I got my new Dually just before christmas has anyone been able to locate any kind of aftermarket acc yet. I am really looking for a winch mount for the front with the grill gaurd. Westin has one in the development but I was hoping to get one soon

Not sure if you ever found a winch mount option, but we were in the same boat so just went ahead and ordered the Rough Country EXO winch mount for the '11-'19 GM.

We knew we would need to do some modifications, but they were actually much less complicated than we expected.

We had to slot the side bolt holes so they matched up to the tow hook bolt holes, and bolted a 1/2" stainless plate on the end of the bracket to reach the bottom of the frame rail.

We're very pleased with how it turned out.

Don't mind the poor picture quality.  I'll try and get some with a better camera and a picture of the bracket.