Jump to content

Recommended Posts

88 chev k1500 after installing bearings in tilt housing they looked an felt to be fully seated but when put the inner race in and shield , the shield didnt seem to snug up like when i removed it is there a way to look at the bearing and tell if it is seated deep enough in the housing how far down on the housing should it be seated thought was bottomed out when installed

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.