1995 Sierra 1500

[Curl510]

Hello my fellow gmt400 brothers. I just got a 95 Sierra single cab roller, been looking for interchangeable parts. Found a 2004 Yukon denali donor. I’m already going to be taking motor and trans. What else from the vehicle is usable? Breaks suspension rear end gas tank etc? Thanks much appreciated 

[CamGTP]

Basically nothing.

 

The suspension stuff would never swap over, completely different era of trucks and different frames. I highly doubt the fuel tank would bolt up.

 

You'll need the engine/transmission, wiring harness, fuse block, pedal assembly and the wiring for the throttle pedal if you plan to stick with drive by wire.

[Curl510]

@CamGTP Ok was going to try testing out fitting the dash or some keep the cluster for gauges. Will be taking all wiring. I would like to go drive by cable route. Currently no motor in truck 

Edited February 7, 2023 by Curl510

[Curl510]

Thank u. Much appreciated for ur information 

Edited February 7, 2023 by Curl510

[CamGTP]

If you want drive by cable you will have to make sure the computer you have has the IAC drivers on the circuit board. Then wire in the IAC/TPS to the computer and all that jazz.

 

Or you will have to source a P01 computer/harness and fuse block if you want drive by cable from the factory. 1999-2002 trucks used cable throttle bodies and 2003+ trucks used drive by wire.