Kevin Hebert Posted May 23, 2023 Posted May 23, 2023 Any info on original file line for this2008 GMC 2500 hd 6.6? Rubber fuel line. Sorry
Niners 365 Posted May 23, 2023 Posted May 23, 2023 Not sure what your asking? Your question is veige. It was a common error code for loss of pressure in Fuel rail line. Attached is the skinny on it.
newdude Posted May 23, 2023 Posted May 23, 2023 P0087 is not a good sign typically. P0087 - Fuel Rail Pressure (FRP) Too Low. Some "possible" indicators to causes that aren't the absolute worst: P0087 Important: If the Change Fuel Filter Warning light is ON with DTC P0087, inspect the fuel filter for a restriction or contamination. -A restricted, kinked, or damaged fuel supply line may cause DTC P0087 to set. -If a low fuel condition is present and DTC P0087 sets, inspect the fuel sender pickup tube for damage or perforations. -Water or gasoline contamination of the fuel may cause this DTC to intermittently set. Refer to Contaminants-in-Fuel Diagnosis. -When ambient temperatures are below 0°C (32°F), the fuel tank pickup screen may be iced over from water in the fuel tank. -When power enhancing devices have been attached to the fuel rail pressure sensor circuits, this DTC may set and adversely affect the fuel system components. -If the fuel pressure relief valve is not torqued correctly, the valve will leak fuel into the fuel return system causing this DTC to set. -The fuel pressure relief valve uses a bite type seal, and proper torque is essential for valve to rail sealing. Refer to Fastener -Tightening Specifications. -High fuel injector return flow may cause this DTC to set. -The addition of fuel system enhancements, such as auxiliary fuel tanks or add on fuel filters may relate to driveability complaints. What needs to be done however is a diesel fuel vacuum gauge needs to be installed at the injection pump to test if the injection pump is properly drawing fuel. On 01-16 Duramaxes, the fuel injection pump pulls a vacuum on the fuel system. There is no "lift pump" or low pressure side pump in the tank, unless an aftermarket one has been added (AirDog is a common brand or FASS). You should see 1–4 inches Hg vacuum when doing a gradual throttle sweep up to wide open. Also, you need some sort of scanner or bi-directional scanner that can read fuel rail pressure.
Kevin Hebert Posted May 24, 2023 Author Posted May 24, 2023 Thanks replaced ful filter and suction line under cab ,
Niners 365 Posted May 24, 2023 Posted May 24, 2023 Glad to hear you got her running. Just a dirty filter huh?
Kevin Hebert Posted May 24, 2023 Author Posted May 24, 2023 And collapsed fuel suction line under the cab, poor design. Used a gates hydraulic hose for the repair.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now