Jump to content

2018 Silverado Intermittent Start

Brian Maxwell

By Brian Maxwell
in Troubleshooting & Recalls

 Share

Recommended Posts

Brian Maxwell Enthusiast

Brian Maxwell

Posted
Posted

My wife woke me stating that our 2018 Silverado wouldn't start on Thursday morning.

I checked it out and sure enough, it wouldn't start.  Grabbed a charger / start assist and it fired right up.  Left charger on the battery and it was down to 2A draw within 20 mins.  Drove to Auto Zone, they said the battery tested 100%, Starter 'looked good', and the charging system passed.

Later in the day, it wouldn't start again.  Grabbed my daughter to start it for me and it turned right over.

I reseated the easy to get to wiring connector at the starter and it kept starting.

Today, wouldn't start in the morning.  Tried it several times and finally started.

Tonight, I got a video of it although my phone didn't start recording right away.    Video below.

 

After the video, I swapped out the starter relay with the trailer relay and hasn't had an issue since.  I'll test again in the morning.

 

Any thoughts?  Such an intermittent failure of a relay seems odd to me.

 

rav3 Senior Enthusiast

rav3

Posted
Posted (edited)

Chek your grounds      clean them and apply some dielectric grease......heck to make sure the all the nut connections on the battery power distribution box that sits on top of the battery are tight.

These are all known issues.

Edited by rav3
Brian Maxwell Enthusiast

Brian Maxwell

Posted
  • Author
Posted (edited)

Checked grounds and power distribution.  Cleaned grounds and covered in grease again.

 

Still had an issue so I jumpered the starter signal wire in the fuse box and still had the issue so I guess just an odd starter failure.  I've never had one intermittently work without a hammer tap.

 

Replaced that and we will see if it comes back.

Edited by Brian Maxwell
rav3 Senior Enthusiast

rav3

Posted
Posted
1 hour ago, Brian Maxwell said:

Checked grounds and power distribution.  Cleaned grounds and covered in grease again.

 

Still had an issue so I jumpered the starter signal wire in the fuse box and still had the issue so I guess just an odd starter failure.  I've never had one intermittently work without a hammer tap.

 

Replaced that and we will see if it comes back.

Are u saying you replaced the starter?

FYI, the starter gets it's ground from where it mounts to the engine/transmission. If it gets corroded there, you will have a bad/weak ground. You can check this by using a jumper cable & clamp over the mounting flang & clamp other end on transmission or engine & see if it will turn over. This happened to me on one of my bmws. I replaced tge start, I took the old one & just connected jumper cables to a battery & it worked fine. Lesson learned for me.

Brian Maxwell Enthusiast

Brian Maxwell

Posted
  • Author
Posted
4 hours ago, CamGTP said:

Starter failures are somewhat common on the 2014-2018 trucks.

Yeah.  The computer said it was failing June 2022 so this one was a replacement of that remanufactured unit under Advance warranty.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Newduramaxh*ar
      DTC P2C48 auxiliary cooling pump

      By Newduramaxh*ar · Posted

      I tried tapping it.  This might sound like a dumb question, you should feel vibration or some type of noise when it turns on? Can someone please verify? Thank you all!
    • Chuck FB
      first oil change - 2026 2500HD gas

      By Chuck FB · Posted

      I feel better now for my own view point and actions or lack there of towards the dealership service theme reading your post and others. GM corporate is who offers the two free oil changes on the HD trucks and I bought my truck in Feb of 2025 and those oil change offers run out within 2 years I believe and I highly doubt I will be using either one of them. I had asked if I could officially give those free services to another customer ( a friend ) and they said no, its all a GM corporate thing based on the vehicle in question. What that service advisor did however was go into a little story about how such and such customer was denied engine warranty because he had done his own oil changes because then they are not documented ... you see where that goes and so an employee playing the game of scaring the customer into having the service work done there most certainly triggered my thought process. At a later date I did talk to the person who handles warranty claims at the dealership and she said to be sure to document the oil changes and keep receipts for the oil and filter ( coped the receipts from cases of Mobil oil and case of filters I bought from them ) and the vehicles VIN, the date of service, mileage etc and staple that together as a record I would give them if that was ever needed and I keep my own log book for services for each vehicle as well. Oh and about 8 months after I bought the truck the dealer starts calling me to offer a maintenance service since they haven't seen my vehicle show up on their system ... for the mere fee of 300.00 Canadian to change the oil and rotate the tires and a few other minor checks and I declined the offer, I get the call again a couple of months later for the same thing and she could tell I was not interested and she asked if they should take my name off the call list and I said yes, do that !.    By the way did you happen to keep your factory oil filter to open it up and see the surprises inside as I expect some will show up as per the odd little sliver of metal shaving and particles that the filter does trap along with bits of grey silicone sealer that come off of the inside edge of mating surfaces. I have cut open every filter so far on my truck although few miles but have changed the oil often and the second filter was vastly better with very little of anything, that first filter was the unsettling one as I expected it would be. 
    • OnTheReel
      OCI, not when but why?

      By OnTheReel · Posted

      I get why they do this…but man…not ideal. I only extract on inboard boat engines because the drains are buried and even then I hate it because it’s easy to leave a quart behind with that method.   They should market it as an “oil refresh” not oil change!
    • KARNUT
      OCI, not when but why?

      By KARNUT · Posted

      I only get oil changed where I can watch. Valvoline pulls through the dipstick into a see thru glass. When done they show me the dipstick. About the only way they can mess up is using the wrong oil. But that secret wouldn’t stay secret long. Honda uses TQ wrenches on everything. You can watch through a plate glass window. Discount tires does that with tires. Trust but verify. 
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      I would not argue that with you. It would be pointless to argue against the truth and you speak the truth.    My question and in fact the entire point of this thread is an exploration into the levers of wear which happens no matter how well we maintain our powertrains.    Some of these levers we exert a good deal of influence over which can and do result is lower wear, longer powertrain life. Some others we are sort of stuck with.    An engine is typically done when the ring to bore seal no longer is able to do the job effectively. Normally the first thing to go in a engine otherwise well maintained and adult driven is this seal.    Looking into the means, methods, products and attitudes that influence the rate of wear seems a worthwhile inquiry to me.     

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...