2024 LED/LTZ front end SWAP!!!

[feedthebob]

5 minutes ago, Daniel6.6 said:

Bro thanks mine is a 2020 high country it already has the led harness i believe should it be the same for the 2024 headlights? And you only bought the headlights,grille,fascia bumper ? That was it the hood is the same?

Correct, the hood and fenders are the same. I don't know  if your headlight plug will work though, the 24s got all new wiring with different plugs. Im pretty sure gen5diy.com has a harness for the 20-23 swapping to 24 headlights. 

[Daniel6.6]

Good looking out brother im looking forward to for this swap… this is my truck rn

[feedthebob]

35 minutes ago, Daniel6.6 said:

Good looking out brother im looking forward to for this swap… this is my truck rn

Dang that things a beast

[Daniel6.6]

Thanks brother one more question does everything fall in place or are there brackets i need for everything bumper? The grill? The middle part of the fascia?

[feedthebob]

9 hours ago, Daniel6.6 said:

Thanks brother one more question does everything fall in place or are there brackets i need for everything bumper? The grill? The middle part of the fascia?

I didn't need anything else, all the brackets and bolts and everything lined up perfectly 

[carkhz316]

On 6/13/2025 at 1:03 PM, Daniel6.6 said:

Bro thanks mine is a 2020 high country it already has the led harness i believe should it be the same for the 2024 headlights? And you only bought the headlights,grille,fascia bumper ? That was it the hood is the same?

The 2020-2023 headlights, both LED and Halogen, use the same 8 pin connector. 2024+ use a 12 pin connector, so you'll need to adapt it in some way.

 

Sorry to hijack, but this is my little conversion. I built the plug and play harnesses myself. My truck ('21) was originally equipped with LED headlamps, which makes the wiring a little bit easier when compared to converting from the stock halogen lights. In that instance, you need to add a relay for the DRL function. Also, if you want the welcome animation to work, you just need to apply a 12V, 70hz, 60% duty cycle to the "animation" wire. Thats it.

 

 

Edited July 27, 2025 by carkhz316

[carkhz316]

 

I forgot to add that the auto high beam works just fine too. Also, the front grille cameras may be incompatible. I had to reuse my original as the new one just showed black/ no image. The coax connectors are the same, so the camera can be swapped from the grille itself easily.

Edited July 27, 2025 by carkhz316

[BC2833]

Just out of curiosity, where did yall mount the resistors and relays that are on the gen5diy harness? I'm getting ready to do the swap but havent research where to mount yet.