2010 Ext Cab 4x4 Z71 After Level Kit Mesurments

[sic lsx]

i hope its my drive way. Stock tires with RC 2" level kit and 95% full tank

 

LF 38.25 RF 38.8

LR 39.50 RR 38.6

 

?????????????????????????????????????

[Chris]

did you check air pressures? weight more on one side than the other? lay a level on tour driveway

[sic lsx]

all at 35 and one at 34. Im going to do it again somewhere else other then my driveway

[Chris]

if you want accurate you need accurate tp's and roll up on 4 scales and measure weight left to right. and your not off much so consider tire wear too.

[Matt_]

im sure some of it is your driveway.

 

Also, no truck measures perfectly side-to-side at any point, even at the frame.

 

And finally... the body panels are adjustable, specifically the front fenders, to get the body lines matched up. So just because one fender measures 1/2" higher doesn't mean that the entire truck is sitting that much higher. I wouldn't worry about it.

[Chris]

i mean look at my sig, my bumber scrapes

[sic lsx]

yeah i know they wouldnt be 100% and im sure my driveway is a little just see what other people think

[captainmorgan00]

I measured my wheel wells before and after i put a level kit on. All mine measure different. But Matt has a good point about the panels being adjustable.

[Big Whiskey]

I always measure mine from the bottom wheel lip to the fender, to take tire pressures out of the equation. The full tank of gas and your driveway could be contributing factors too. However, I wouldn't worry about it. On my last 4 trucks, all of them were different side to side. A couple were up to an inch different. Plus, with your's being a 2010, it may settle a little as you put some more miles on it.

[sic lsx]

WWhy i like my camaro i upgraded to Coilovers they all r the same lol.