Pulling Axle / Replacing Backing Plates

[roadster_nh]

2003 Suburban 1/2 Ton 4x4:

 

I need to replace the rear brakes and the backing plates and I'm wondering how difficult this is for someone (me) who has previously replaced brakes, installed a water pump etc. I've never pulled an axle, but from what the shop manual describes, it doesn't look too bad. Am I over my head on this? Advice and comments appreciated. Thanks.

[rockcrusherrevived]

2003 Suburban 1/2 Ton 4x4:

 

I need to replace the rear brakes and the backing plates and I'm wondering how difficult this is for someone (me) who has previously replaced brakes, installed a water pump etc. I've never pulled an axle, but from what the shop manual describes, it doesn't look too bad. Am I over my head on this? Advice and comments appreciated. Thanks.

 

with your mechanical knowledge you'll have no problem. it is a dirty, smelly job.

[roadster_nh]

Thanks - very helpful. My shop quoted me about $1000 to do the rotors, pads, backing plates, bearings, and seals. Sound about right?