Jump to content

Recommended Posts

Posted

I have a 2006 Silverado 1500 with the following problem

Intermittently - All dash gauges cut out and charging light, security warning light- light up. radio also cuts out ... I think electric door locks and windows also don't work....once I depress the brake pedal all comes back until it happens again 10 sec to several minutes later. Dash lights, headlights, tach, speedometer, heater fans stay on - engine never skips a beat...happens moving and idling...brake pedal always fixes it ... can happen 10 times per minutes or can go 5-10 minutes w/o it happening... very frustrating -any suggestions?

 

Posted

Always check the battery condition. Battery cables/connections including body grounds

Posted

Is the megafuse the 125 amp one that is not visable unless you remove the plastic surrounding the the fuse box under the hood? I've seen reference to a 175 amp one on the firewall in 2008...but doesn't appear to be there on the 2006?

Posted (edited)

My truck in a 2006 GMC Sierra. A couple of years ago I had a bunch of unusual and seemingly unrelated electrical problems. Check engine light illuminated dimly, cruise control worked but would not shut off with switch, only by pushing brake pedal, interior lights flickering sometimes, etc. It turned out that mice had chewed the hell out of the wiring under the main fuse panel mounted in the engine bay, left front fender. I spent an entire weekend splicing and re-insulating to fix it all. It isn't real easy to get at the wires under the fuses, you have to pull the fuse panel section off of the rest of the big plastic box, but if you don't find anything else wrong, you might look under there. I now put mothballs in plastic holders under the hood to keep the mice out.

 

Oh, and neither my OBDII scanner nor the dealer's superdooper scanner showed any fault codes.

Edited by 06pirate
Posted

My truck in a 2006 GMC Sierra. A couple of years ago I had a bunch of unusual and seemingly unrelated electrical problems. Check engine light illuminated dimly, cruise control worked but would not shut off with switch, only by pushing brake pedal, interior lights flickering sometimes, etc. It turned out that mice had chewed the hell out of the wiring under the main fuse panel mounted in the engine bay, left front fender. I spent an entire weekend splicing and re-insulating to fix it all. It isn't real easy to get at the wires under the fuses, you have to pull the fuse panel section off of the rest of the big plastic box, but if you don't find anything else wrong, you might look under there. I now put mothballs in plastic holders under the hood to keep the mice out.

 

Oh, and neither my OBDII scanner nor the dealer's superdooper scanner showed any fault codes.

 

This is where I suspect the problem is (main fuse panel)...if it were in the dash circuitry - I don't think the radio would be involved and if it was the ignition switch..I don't see why some accessories but not others...the brake pedal correcting it 100% of the time has me perplexed....I will head under the fuse panel under the hood megufuse and all...it was sitting for a bit - so mice a possibility

  • 1 month later...
Posted

I have a 2006 Silverado 1500 with the following problem

Intermittently - Dash gauges (voltage, oil pressure, etc) cut out and charging light, security warning light- light up. radio also cuts out ... I think electric door locks also don't work....once I depress the brake pedal all comes back until it happens again 10 sec to several minutes to hours later. Dash lights, headlights, tach, speedometer, heater fans all unaffected - engine never skips a beat...happens moving and idling...brake pedal always fixes it ... can happen a couple times per minutes or can go 5-10 minutes w/o it happening even hours... very frustrating -any suggestions? Ignition wiring? Could brake circuit be backfeeding power?

  • 6 years later...
Posted

Aluminum oxide is the demon.    Aluminum stud, aluminum nut & aluminum braided cable, engine body ground. removed from firewall cleaned put back no gremlin.  If the problem is at the block (hard to get at) just run a 14 - 16 gauge copper wire from stud to block, alternator bracket has a 8 mm bolt holding a wire clip (that was first thing I did), stopped in the middle of no where after gremlin attack dash gauges door locks headlights warning lights radio clock reset.  Went to start turning key nothing at all.  Key in the on position with a coat hanger touched body ground bolt and block the key in ignition alarm started dinging.  used a lamp cord that was in the bed stripped it rigged it up and no problems rest of 30 miles home.  once home pulled ground strap from firewall cleaned with wire brush reinstalled not a flicker from headlights when brakes are applied nothing demon/gremlin completely gone.

  • 11 months later...
Posted

I realize this is an old post but Solas, did you figure it out?

 

I have an 06 Z71 and its doing the exact same thing. Warning lights pop up on dash, all gauges drop to zero, radio turns off, windows/doors wont work, etc but truck still runs. If I have AC on , fan will continue blowing but compressor not sending cold air. If i turn the truck off and restart, its usually fine.

 

Fairly new Interstate battery, will check ground and connections but this is driving me crazy

  • 6 months later...
Posted
On 8/21/2021 at 9:14 AM, DeeboSC78 said:

I realize this is an old post but Solas, did you figure it out?

 

I have an 06 Z71 and its doing the exact same thing. Warning lights pop up on dash, all gauges drop to zero, radio turns off, windows/doors wont work, etc but truck still runs. If I have AC on , fan will continue blowing but compressor not sending cold air. If i turn the truck off and restart, its usually fine.

 

Fairly new Interstate battery, will check ground and connections but this is driving me crazy

Did you ever get this issue resolved? I cannot find out why my truck is doing this and shops are charging ridiculous amounts to go through my system.

  • 1 year later...
  • 1 year later...
Posted

I’m currently having similar issues on my 2006 Chevrolet Silverado. 
 

My doors won’t power unlock or lock , windows won’t go up and down, radio doesn’t turn on, my four gauges are not working( battery, oil, pressure, temperature, gas) and interior lighting only turns on when I manually pushed the buttons. 
 

My battery light is on so I replaced the battery because it had gone out but didn’t fix the problem. 
 

My ABS light is on. 
 

No check engine light.

 

I checked my fuses and relays and they all look good. 

 

not sure the problem. 

  • 4 weeks later...
Posted

2007 Chevy Silverado having trouble with the cluster, radio and climate control coming and going plus the blower motor runs with not key in truck

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • I just brought home a 2020 GMC 1500 Denali.  She has 53K miles on her and I want to change out the fluids over the next few weeks.  I see the diff covers don't have drain plugs.  Any suggestions where I can pick up front and rear diff covers with drain plugs?   Thanks,   Bob
    • Well, the dealership got the compressor and installed it. Air at the vents seems nice and cold as it should be. The service manager said the repair has a two year warranty and unlimited mileage. Hopefully I don't have to use it. The dealership i went to was one where I bought my 2014 half ton silverado. In 10 years and 168k miles on the truck anything I needed done and two small recalls they were always very good to me. Not a huge dealer either. I think they treat people well because they want you to come back. I have dealt with a different dealer that was too big to care about an individual. Just my two cents.
    • Hi All, I operate my 2021 3500 SLT most of the time with the tailgate off and in a crate because I have a slide-in camper. However, at least once a year, I take the camper off and put the tailgate back on. Recently I installed the tailgate, but had a hard time getting the connector bail to swing to the fully latched position. The connector seems to fully seat, and everything works, but the bail doesn’t swing to fully latched position.  It swings almost there but stops and I am afraid to push it any harder.    Does anyone have any advice on cleaning or lubrication or anything else I should be doing?  i know how to properly operate the connector. During the time the tailgate and connector are off, i have a double plastic bag over the truck connector secured with rubber bands to keep it clean, but it still had some dust in it this time when I blew it out with compressed air. I didn’t want to spray it with anything other than air without doing some research. Thanks. 
    • There are a lot of spammer's that do that, quote something and add some commentary to make it seem legit, but modify the quoted text a bunch making sure when posted it's long enough to be "click to expand", and either immediately insert a spam link, or come back after some time and edit it to add the spam link.
    • Hello @jaszr2 Do you have a link for the item? I put a replacement bumper on my truck and consequently had to relocate the shutters. I studied on them a while, and figured if you left a couple key blades, you could get most of the airflow with probably no throwing codes.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...