Jump to content

Adding Power Seats 2010 Sierra SL x-cab

HiSierraMan

Recommended Posts

HiSierraMan Enthusiast

HiSierraMan

Posted
Posted

I am looking to add power seats and I have a few questions. I found a set of bucket seats from an 07 Avalanche, will these fit my truck?

 

Also, what would I have to do for wiring or harness changes? In theory it seems all I would need would be power and ground beens all the motors/controls are on the seat base.

 

Any help, harness numbers or advice would be appreciated.

 

sent to you by me

Zebrafive Enthusiast

Zebrafive

Posted
Posted

Do your seats have air bags? If so, make sure the replacements also have air bags.

I am not sure if the air bag connector will be separate or combined with the power seat connector.

For the power part, yes it should just need a power and a ground wire. Power seats use circuit breakers, not fuses. You should find a circuit breaker listed for seats with the fuses.

Heating will be more difficult, the switch is on the door not the seat.

If the seats have memory that might not be possible to make that feature work.

oldscsc Enthusiast

oldscsc

Posted
Posted

Adding heated seats required a switch and the appropriate wiring in 2002 and earlier trucks.

 

After the electrical architecture change in 2003, the heated seat function was controlled by modules in each door. Adding and programming the modules was difficult and very expensive. This goes for 2003-06 pickups; however, I can't see GM going back to a non-computer controlled circuit.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • 2017Z
      2020 Trailboss 6.2 replacement

      By 2017Z · Posted

      Looking for advice from this group. Took my flawless 2020 6.2 TB to an unnamed shop for routine rear brakes and oil change. Tech forgot to put oil back in after the full service and needles to say, destroyed my engine.  It’s all on their shop video so they are responsible.   I had my Chevy dealer do the analysis and they confirmed its compromised and said engine replacement. The manager said they only get GM reman engines from GM with full 3 yr warranty and the one they would put in is not same as what’s they are swapping out on 21-25 for recall.    I am looking for advice why that would be a different engine because obviously I had the good 6.2 year and replacing it has my concerns with that recall for 21-15   Also what’s the pros and cons of accepting the engine swap vs telling the shop that bricked the truck to pay up so I buy a new truck. I’m concerned about stigma resale eventually if I just decide to get rid of it after the swap or other issues showing up after the swap out.  
    • GN2018
      AFM Disabler Question

      By GN2018 · Posted

      Just looked up my records.  I've never gone over 5000 miles between oil changes.  At 46K miles, I have 10 oil changes.  I hope that will help.  I also installed the disabler last year.  I've still had a few times when it didn't seem to engage (which I can tell because the start stop feature kicks in), but for the most part, I think it's working.  For some reason, GM did not include the number of cylinders running in the information screen like I had on other models.  In my Cadillac, it shows me when it's running on 4 cylinders on the fuel milage screen.  I can't find that on my '21 Denali.
    • davester
      Wiring Help, Please

      By davester · Posted

      you might read through the info on gmupfitter.com for your truck, to find a good power source.
    • Grumpy Bear
      AFM Disabler Question

      By Grumpy Bear · Posted

      Melling I believe is/was the OEM on the lifters who explored this problem some years ago. The white paper they generated on the topic indicated two items of note when I read it. 1.) They only fail on the switch. Prevent the switch, prevent the failure. 2.) The majority fail due to deposits messing up the timing of that switch. Anyway that's what I got from it.    Mine have always been active, 195K+ now, and my oil maintenance is surgically clean.    Of course this assumes good parts. That is no heat treat issue or machining flaws. I get comfortable that these issues are in the rearview mirror by about 30K. IMHO naturally. 
    • Chuck FB
      2 speed transfer case optional now?

      By Chuck FB · Posted

      Yes, the key seems to be with the half tons that if it has the Z71, then it definitely has the two speed. What got me was that the two speed AND the lower geared towing package option could not be chosen together the last few years unless it was mated up to the 6.2. Want the 3.0 duramax and 3.73 tow gears ... nope, can't get the two speed transfer case ( neighbor son realized that after he had bought his used 3.0 half ton .. where the frick is the low range ? ! ).    I am still unsure which truck series, the half ton or the HD truck that the original poster is referring to for sure other than yes his question is in the HD section of this forum but that doesn't guarantee the question got asked in the right section.  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...