Plug & Play Heated Steering Wheel Harness 2007-2013

Zebrafive · December 23, 2014

Harness to provide power and ground for heated steering wheel install. This harness connects to the dash side of the SIR coil light green connector and goes to the I/P Junction Block space X14. Delphi connectors, terminals, terminal locks and 18 gauge wire. $25 shipped in USA. Will ship to Canada $30.

Message me if interested

2017SierraSLT · December 23, 2014

That's a great looking harness. This mod is on my to do list once I obtain a ebony non wood grain heated steering wheel.

Zebrafive · December 23, 2014

Thanks! You will also need a new SIR coil / Clock Spring part number 22911594 for a 2013

Btuggle88 · December 24, 2014

Do you make these or do you get them somewhere cause I am interested in installing a heated steering wheel in my truck.

Zebrafive · December 24, 2014

Do you make these or do you get them somewhere cause I am interested in installing a heated steering wheel in my truck.

I made it.

Btuggle88 · December 24, 2014

And this just plugs in to the new clock spring and and new steering wheel and works?

Zebrafive · December 24, 2014

The new clock spring has all the connectors of the original clock spring PLUS a light green connector on each side. Steering wheel side connects to the heated steering wheel. Column side is where my harness comes in. It connects to the clock spring and I/P Junction Block. Once installed heated wheel is ready to use. No BCM programming/flashing required.

Zebrafive · February 7, 2015

TOP

AUTOGUY · February 9, 2015

Do you still sell these? I might need one. I have a 2013 Silverado LTZ that I installed a heated wheel and clock spring, but never hooked up the wire because it was not pre wired like my 2007 Escalade EXT was.

Zebrafive · February 9, 2015

Do you still sell these? I might need one. I have a 2013 Silverado LTZ that I installed a heated wheel and clock spring, but never hooked up the wire because it was not pre wired like my 2007 Escalade EXT was.

Yes. It should be plug and play on a 2013. You should verify you have 12v at pin 7 of X14 in the under dash junction block ONLY when the key is ON. I have verified that for 2011, but do not have a 2013 to check, but think it should be the same.