-
Recently Browsing 0 members
- No registered users viewing this page.
-
Forum Statistics
250.3k
Total Topics2.7m
Total Posts -
Member Statistics
342,676
Total Members8,960
Most Online
-
Who's Online 11 Members, 0 Anonymous, 736 Guests (See full list)
-
Latest Articles
-
Posts
-
Doesnt take an engineer to read a dipstick. Otherwise the manufacturer would require dealership oil level checks. Not brain surgery either. -
Don’t get hung up over this. No disrespect intended. People have a different opinion of what constitutes using oil. I stated mine. -
By asilverblazer · Posted
To be clear I'm not arguing whether your vehicles do or do not use oil. I am interested in continuing a technical discussion about what amount, if any, we can measure as being 'used' or 'lost'. As I stated, I measure the oil volume that I have drained from the oil pan and compare that directly to how much I put back in. There is always more going in than what came out. Generally, at a minimum, 1-2 cups, at most 1-1.5 quarts. The smaller discrepancies, were smaller oil capacity engines (5 quart load) and the larger discrepancies were on larger oil capacity engines (9 quarts). Generally, these never showed any 'measurable' oil loss per the dipstick(s). Oil was always within the marked area. Could it have been higher in the marked area one time vs another, I have to assume so, but the level on the stick never warranted a more significant dipstick reading accuracy check. I've come to the conclusion that so long as the oil level is within the range on the dipstick the volume is acceptable. Any loss that doesn't exceed the published acceptable use or fall below the dipstick marking is not considered a problem, meaning, the amount that I see being lost are not 'abnormal' or enough to warrant further investigation. Could it be that your measurement method isn't accurate enough to show an amount of oil loss? (This isn't an insult; I am exploring the measurement limitations of dipstick readings.) To wit, an oil pan that spreads a large volume over a greater surface area compared to a narrower pan would show variations in their measured volume quite differently on a dipstick. -
By asilverblazer · Posted
Give or take, all but my earliest vehicles had that short an interval. To be sure any vehicle I've touched this century, generally they've all been on a minimum 5k interval. -
I appreciate it. I got another quote locally for a remanufactured engine + labor with a 3 year 100k mile warranty for 9k flat with a $500 rebate. Very reputable business in my area and they do good work.
-
-
GM-Trucks.com Clubs
-
Black Truck Club
Open Club · 612 members
-
White Truck Club
Open Club · 380 members
-
Canadian Owners Club
Open Club · 282 members
-
Red Truck Club
Open Club · 156 members
-
diesel 3.0
Open Club · 279 members
-
Texas Owner's Group
Open Club · 371 members
-
NorthSky Blue Club
Open Club · 118 members
-
Midwest Owner's Group
Open Club · 212 members
-
2015 Custom Sport Club
Open Club · 5 members
-
GM Snow Plowing Club HD
Closed Club · 14 members
-
-
Popular Contributors
-
.thumb.JPG.2c573de60d3a3a4407c7d92298db46dd.JPG)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.