Jump to content

20x9 +1 offset w/ 295/55/20 tires


Recommended Posts

Posted

So I've decided to go with Fuel Maverick 20x9 +1 offset (this can be changed to a more positive offset) with AT2 XT tires, has anyone had a similar setup with a 2.5" level kit, id like no rubbing and would not like to do much trimming if at all. thanks guys! there going on a 2015 1500 HC

Posted

So I've decided to go with Fuel Maverick 20x9 +1 offset (this can be changed to a more positive offset) with AT2 XT tires, has anyone had a similar setup with a 2.5" level kit, id like no rubbing and would not like to do much trimming if at all. thanks guys! there going on a 2015 1500 HC

You should be fine. I've seen ppl with 33x12.5 on with 0 offset and a 2in level on here that claim they don't rub. Your tires are just a tad smaller.

Posted

I have Fuel Maverick 20x9 +1 offset with the RC level and 305/50/20 tires. No rubbing, not even close I think I could have even squeezed 305/55 in there. I wanted to be sure I didn't rub and I wanted my speedo to be fairly accurate, since I threw these on a truck with only 500 miles. When I replace I will probably go 295/55

 

the 295/55's are .8 inches taller than the 305/50 so I am fairly certain you will not rub.

 

12891596_10101061153626766_7991183570762

Posted

thanks, do you know how

 

I ran those tires with no level on factory 20s no rubbing at all I did end up leveling the truck for

how much play room did you have? I think factory 20s are +27

Posted

there was enough room that they did not rub even when turning while hitting bumps offroad. it looks a lot better with the 2.25 leveling kit.

Posted

Hey man, do you have any pictures? i would love to see what this looks like, as i have the 2.25" level, still sitting on stock wheels and tires for now. very difficult to make up my mind!

 

there was enough room that they did not rub even when turning while hitting bumps offroad. it looks a lot better with the 2.25 leveling kit

Posted

You will be fine. I have a 2 inch level with 305 55 20s with 20x9 Fuel Mavericks + 1 and ATZ p3s and i don't rub.

Posted

You will be fine. I have a 2 inch level with 305 55 20s with 20x9 Fuel Mavericks + 1 and ATZ p3s and i don't rub.

How did the 3.08 gears handle the bigger and heavier tires??

Posted

There is a noticeable difference with the heavier tires but its that bad until you tow. I tow three to four times a week and I am re gearing to 4.10s when Isave up some cash.

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • Not sure about DFM tech but i know there's a stop/start deactivation button. 
    • I could be interested if they axed cylinder deactivation and at least have a button for stop start. I’m sure the HP numbers will be higher. I would want a longer warranty to help build confidence. I’m a less is more guy as I get older. A V-8 work truck model would be my choice. I know a few outfitters for custom additions I prefer. 
    • It's official. GMC pulled the covers off the next-gen 2027 Sierra 1500, and we got the first official look. Full breakdown here: https://www.gm-trucks.com/next-gen-2027-gmc-sierra-1500-v8-trim-changes/   The quick hits: SLE and SLT are dead. The new core retail trim is just called "Elevation". Two new V8s, a 5.7L and a 6.6L built with high-performance Corvette architecture roots. No horsepower or torque numbers yet. The 2.7 TurboMax finally ditches the old gearbox and gets the 10-speed automatic. AT4X moves to larger standard 35-inch tires with front and rear e-lockers, Multimatic DSSV dampers, and heavy-duty Jounce Control Dampers. Over 60 inches of combined display on Denali Ultimate and AT4X, complete with a motorized articulating center screen and an adaptive passenger screen. Seven simplified trims across the entire model line to clean up ordering confusion.   So let's get into it: New 5.7L and 6.6L gas V8s with custom active exhaust tuning and a Corvette connection. Is this the exact engine lineup half-ton traditionalists have been begging for? Purging the iconic SLE and SLT names after all these years to lean entirely on Elevation as the high-volume core. Bold move, or a mistake? That motorized articulating 16.3-inch screen that slides up to reveal a hidden dashboard vault. Awesome mechanical theater, or does it make you nervous about long-term durability? Physically lowering the headlamps in the front fascia to improve road courtesy and stop blinding oncoming traffic. Smart real-world engineering, or does it hurt the truck's aggressive stance? What trim are you putting your name down for on day one? Drop your first impressions below.  
    • My overnight hospital stay turned into five.  I developed a post operative fever and an erratic  heart rate.  A blood clot in the lungs was the culprit.  This is apparently a common post surgical complication and easily remedied.   I was the youngest in a four bed ward and a Doctor with a Geriatric specialization was in charge of my care.  All of the nurses were good and some were outstanding at dealing with old people.  It was very evident that my age triggered a different level of care!  My advice to any senior going for a hospital stay is to have a trusted family member advocate visible.  If not, you will still be well cared for, but you may discover that your voice  isn't as strong as it once was! 
    • $4.25 85 oct. in town, down 50 cents.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...