Jump to content

Recommended Posts

Posted

Good question, I am planning on installing a SiriusXM stratus 7 receiver and was wondering the same thing.

Posted

I found a place to tap into auxiliary 12VDC. Under the drivers side dash there is an extra connector X260. It has a blank mating connector pugged into it. I will be going to GM to see if I can get the pins.

In the GM up-fitters website you can download the breakout but the Black wire on 1 is ground and the Violet/Yellow wire on 6 is the accessory power. It is a 14 pin plug.

 

 

x260.doc

  • Like 1
Posted
I found a place to tap into auxiliary 12VDC. Under the drivers side dash there is an extra connector X260. It has a blank mating connector pugged into it. I will be going to GM to see if I can get the pins.
In the GM up-fitters website you can download the breakout but the Black wire on 1 is ground and the Violet/Yellow wire on 6 is the accessory power. It is a 14 pin plug.
 
 
x260.doc
Thanks for the info. Going to use this tomorrow to hook up some additional USB Charging Ports.

Sent from my SM-N960U using Tapatalk

Posted
On ‎8‎/‎31‎/‎2019 at 5:53 PM, Smoothbassman said:

Thanks for the info. Going to use this tomorrow to hook up some additional USB Charging Ports.

Sent from my SM-N960U using Tapatalk
 

Keep me posted on this. I would like to set up an additional USB charging port and keep it clean like a factory install. If you can post a write up or PM how you did it I would really appreciate it.

  • Like 1
Posted
On 8/30/2019 at 6:17 AM, RobZ said:

I found a place to tap into auxiliary 12VDC. Under the drivers side dash there is an extra connector X260. It has a blank mating connector pugged into it. I will be going to GM to see if I can get the pins.

In the GM up-fitters website you can download the breakout but the Black wire on 1 is ground and the Violet/Yellow wire on 6 is the accessory power. It is a 14 pin plug.

 

 

x260.doc 127 kB · 30 downloads

Did GM sell you the connector pins? If not where did you find them? Thanks 

Posted

I have them on order from GMpartsdirect.com

Have not received them yet. Today I will swap the 50 amp fuse (F27/F28) in the passenger side fuse box so the accessory power will be tied to the retained accessory power and will try tapping into the extra pin near the F28.

Posted (edited)

Part number is listed in the attached word document. Two different pin sizes. Also swapping the fuse did not change the extra pin to RAP. So I wired the sirius power cord to the cigar lighter wires

Edited by RobZ
added content
Posted

If I am reading the word file right the terminals are 13575818 and 13575824? Just confirming because gmpartsdirect.com lists those numbers as "wire" and a little over $6 each.

Posted

Yes, they are the pin crimped to a 6" piece of wire with a butt connector, not cheap

  • 2 years later...
Posted

Does anyone know what fuse the violet/yellow wire is on?? I found the x260 connector yesterday, but pin 6 is not hot when the truck is running. I'm thinking it's a blown fuse.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Point of the post sir was that while both wages and cost are rising EVERYWHERE; the cost is rising faster EVERYWHERE than the ability to buy EVERYWHERE. We're not going down the location rabbit hole. I'm aware of what economic migration is. I've lived in four states including Texas.   It's what "Purchasing Power" means.   I'm not telling you what I think. I'm telling what the government, your government, data shows.   It wasn't an argument. It wasn't a suggestion. It was a statement of FACT. You are absolutely entitled to your own opinion. Your not entitled to your own facts. If you and I were, they wouldn't be facts.    fact /făkt/   noun Knowledge or information based on real occurrences. "an account based on fact; a blur of fact and fancy." Something demonstrated to exist or known to have existed. "Genetic engineering is now a fact. That Chaucer was a real person is an undisputed fact." A real occurrence; an event. "had to prove the facts of the case." The American Heritage® Dictionary of the English Language, 5th Edition • More at Wordnik   If you'd like to disagree call your Senator or Representative and let him know his departments are in error. But you and I? We are not doing this. 
    • Probably a one and done post, but do you have a CEL on the dash? Was having issues with my transmission, fortunately only a week, and it turned out to be the transmission harness. Valve body was in good shape, so new harness with all the sensors attached, new fluid, and filter. Seems to have worked so far?
    • Two interesting tidbits of information which are NOT related were just released.   One, regarding the possible thrust bearing issues / engine failures with the 3.0. Demonworks just did a segment in which they believe they may have found "a" or "the" cause of thrust bearing failures: A missing thrust bearing. If the engine doesn't have all its thrust bearings from the factory, the missing bearing can cause extra play which ends up destroying a nearby thrust bearing which then sends metal through the engine.       Of other importance, Lake Speed Jr released some interest information regarding oil weight selection for the 3.0. Comparisons of:   AcDelco 0w20 Dexos D Mobil 1 ESP x2 0w20 Dexos D Mobil 1 ESP x2 0w30 Mobil 1 ESP x4 0w40. Mobil Delvac 5w40   Spoiler alert: The Mobils are PAO Ester -base and the ACDelco is a Group III base. Mobil shows lower wear in their tests for similar weights. Additive packages between 20-30-40 weight ESP's appear to be the same, but only 0w20 is Dexos D licensed. Wear is even more reduced with 30 and 40 weight ESP although all perform very well and resist shear and provide very similar viscosities within temperature operating ranges in the 3.0.   There are even more surprises, so just go watch it.    
    • Hello Guys I'm new to the form,         I just put a 7-inch Rough Country lift on my 2016 GMC Sierra 1500 with the 5.3 and I also put a Borla exhaust on it. But I noticed when I'm in park or in neutral and then I rev my truck up really quick there is a bad click noise and I think it's coming from the motor somewhere. Anyways I got a video of it I will attach below I was just wondering if you guys think its rod knock or lifter tick or something like that because I know the AFM kind of made the lifters weak on these trucks.       Thanks!!!!! RIP - Chevy 5.3 IMG_6043.mov    
    • We’ll have to agree to disagree. I didn’t experience or know anyone who had a decent car after 100K miles in the 60s through the 80s that were daily commuter vehicles. Unless they were collector vehicles. Of course things cost more due to inflation. But we also make more money. The biggest money drains these days are things people think they need today versus what we require back in the day. Like cell phones and internet as examples. Another example is where you live. Cost of living varies from state to state. I would need twice the money to live in NJ vs Texas in retirement. The car you recently purchased was less than my first car with inflation at 3000$ in 1973. I didn’t have air, electric windows, cruise etc. Purchasing power is equivalent, you just have to do the research. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...