LED Strip with Sequential Turn Signal Install

[FuriousFuria]

I recently bought an LED strip that also has a sequential turn signal I can connect if I want to (separate wire). Problem is, our turn signals don't connect to any wiring harness for me to tap into. I thought maybe I can tap straight into the turn signal fuse, but it looks like there are no turn signal fuses either and it goes straight into the BCM possibly? Anyone have any ideas how I might be able to splice this in somewhere or am I SOL?

[Cohocarl]

I think this thread might have some info that might be handy.

[FuriousFuria]

10 minutes ago, Cohocarl said:

I think this thread might have some info that might be handy.

Ah unfortunately that won't help. This is for the front end, not the rear end. I can't hook up to the trailer brake/turn signal because then the Amber's will just stay on all the time I believe, or at least Everytime I hit the brake

[Cohocarl]

Oops..sorry.  It's been a long day.

[Smoothbassman]

Looking at the electrical semantics you have a couple of wires green/violet and blue/white that sends out the turn signals to the lighting module from the BCM.

With these trucks going to control circuits and circuit boards in the simplest things. You are going to have to get creative in integration. I had to use a relay to get my led bed lights to work as the computer detected too much load and shut the system down. The relay allowed me to work around that.

You can find the full electrical schematic on this site so you can try and figure it out.

https://www.gmupfitter.com/files/media/photo/1161/19_Silverado_1500_Body_Builder_2019FEB13.pdf

Good luck!!

Sent from my SM-N960U1 using Tapatalk