Jump to content

6 speed Acadia trans 2-3 hot (only) transmission flare

dsgvw
 Share

Recommended Posts

dsgvw New Member

dsgvw

Posted
Posted

 

Looking for any and all advice as I’ve been to the dealer 7x now with no resolution.

 

2017 GMC Acadia 6 speed 2WD Denali

35000k

 

Replaced already:

TCM

Transmission valve body

Reflashed trans software

Torque converter

Fluid flush numerous times through all this effort by the dealer

Spark plugs

Throttle body

 

Recent video footage of issue.:

 

 

Car only slips after trans warms up, ~10 mins after start from cold. Basically 2-3 shift feels like it drops into neutral for a split second before 3rd grabs. But.. only does this hot, never when trans is cold. I’m starting to think it’s a pressure issue or over/under fill? I need a trans expert to help me as I can’t stand it but otherwise love this vehicle. It’s ruining everything about it. Dealer is worthless at this point and refuses to replace whole transmission under warranty so far.

 

Any suggestions? Dealer claims output speed sensor is fine also last time they had the trans apart after checking the sensor upon my request.

 

Thank you!!

 

 

 

  • 4 months later...
  • 1 year later...
red bear New Member

red bear

Posted
Posted

Transmission flair just started on my 2017 Acadia - 30K miles.  Same symptom - delay shifting from 2nd to 3rd.  Did you ever resolve the problem?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • KARNUT
      2027 GMC Sierra: Official Discussion

      By KARNUT · Posted

      It wouldn’t have happened if the government hadn’t mandated outrageous fuel mileage standards. It does very little for the consumer. It adds cost. Back during Covid there was a chip shortage. They gave a rebate for your truck if it didn’t have the chip to turn on cylinder deactivation. It was 50$ because at best you may see 1/2 a mile increase per gallon. Splitting hairs each fuel mileage trick wasn’t mandated. The government doesn’t do the engineering work and say use this until it’s already in use and they like it. The fuel mileage was mandated. And those add ons the results. There’s a mandate and they are the results.
    • newdude
      2027 GMC Sierra: Official Discussion

      By newdude · Posted

      It was never mandated.  Ever.    Automakers were incentivized to install it by getting CAFE credits to help with their vehicle fleet fuel economy scores.  They were being handed money/CAFE credits to install it.  Which is NOT a mandate.       The current admin removed the incentives that were behind them installing it.       
    • lanaderay
      5 Best Slide Down Gameplay Tips! 

      By lanaderay · Posted

      Are you playing Slide Down endlessly but your score is still low? Are you constantly crashing into obstacles as the game speed increases? Don't worry, this article will share 5 invaluable tips to help you master the race and impress your friends. Golden Rules 1. Look one step further. The mistake of 90% of new players is only staring at their character. The secret of experts is to look towards the top of the screen (where the slide is about to appear). This gives your brain an extra 0.5 - 1 second to process the situation and determine the direction of movement before the obstacle approaches. 2. Use gentle movements; don't swipe too hard. Slide Down is very sensitive. Moving your finger too forcefully or with excessive amplitude will cause your character to be thrown off course or crash into a wall. Practise moving your finger with small, decisive, and precise movements. 3. Don't be greedy for gold in dangerous locations. Gold coins are tempting for buying skins, but life is more important. If you see a gold coin right on the edge of a cliff or next to a spike trap, ignore it. Our goal is a High Score, and your score only increases if you survive. 4. Make the most of Power-ups. During the slide, you'll encounter items like Magnets (attract gold) or Shields (temporary invincibility). Never miss them! Especially the Shield, it's your "get out of jail free card" to help you get through those deadly fast sections. 5. Stay calm when speed peaks. When your score exceeds 500 or 1000, the game speed will be very fast. At this point, don't try to think logically; let your natural reflexes work. Take deep breaths and don't panic. Apply these 5 tips to your next game, and your leaderboard will surely improve dramatically. Good luck climbing the Slide Down leaderboard!
    • lingyuair
      Why I Recommend a Desiccant Air Dryer for Cleaner, Drier Compressed Air

      By lingyuair · Posted

      If you use compressed air regularly, one problem you cannot ignore is moisture. Water in the air line can cause rust, unstable air pressure, poor tool performance, and even damage to sensitive equipment. That is why I highly recommend using a desiccant air dryer. A desiccant air dryer is designed to remove moisture from compressed air by using drying materials such as activated alumina or molecular sieve. Compared with basic water separators, it can achieve much lower dew points, making it especially useful for applications that require dry and stable air. For workshops, painting systems, pneumatic tools, CNC machines, laser cutting equipment, and industrial production lines, a desiccant air dryer can make a big difference. It helps protect equipment, improve air quality, reduce maintenance costs, and extend the service life of the whole compressed air system. Another advantage is reliability. Many desiccant air dryers are built for continuous operation and can maintain stable drying performance even in demanding environments. For users who care about long-term efficiency and equipment protection, this is a smart investment. When choosing a desiccant air dryer, I suggest paying attention to air flow capacity, working pressure, dew point performance, regeneration method, and maintenance requirements. A good model should match your compressor system and actual air consumption. Overall, if moisture is causing problems in your compressed air system, a desiccant air dryer is definitely worth considering. It is practical, efficient, and highly useful for anyone who needs clean, dry, and reliable compressed air.
    • Jsdirt
      2027 GMC Sierra: Official Discussion

      By Jsdirt · Posted

      My brand new 2007 Silverado's wax frame was rust from end to end partway through it's SECOND winter here in MA. That stuff is completely useless.    

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...