AT4 1" or 1.5" Level or others?

[sweatandsteel]

7 hours ago, Whiskey891 said:

 

Nice! Here comes my order!

[tvette1993]

On 6/11/2020 at 8:20 PM, Supercup said:

Stayed with 18's and factory Duratrac's for now.  If I end up doing BDS lift - I will have to go to 20's - and at that time will add larger tires.  also note in these photos I have the RL half inch taller block in rear - in photo with stock wheels it was not in and the front was 0.25" high over back, now reversed. 

 

RL 1/2" taller block?? I could only find a 2.25" block or a 3" block on the Ready Lift site?

 

Do you have the model number of the block you used?

 

[Supercup]

9 hours ago, tvette1993 said:

RL 1/2" taller block?? I could only find a 2.25" block or a 3" block on the Ready Lift site?

 

Do you have the model number of the block you used?

 

It was part of the SST 2" level kit for AT4 - looks like on their website they are 3" blocks - when they went on we measured versus stock AT4 blocks and they were 1/2" taller.   So looks like they are the 3" on their site. 

 

 

[Whiskey891]

On 6/16/2020 at 5:28 AM, sweatandsteel said:

Nice! Here comes my order!

After alignment and new wheels/tires. 20x9 +1 offset Fuel Rebel on 305/55R20 Duratracs.

[Fsu96]

Bump

 

[LKGRenegade22]

On 6/16/2020 at 12:25 AM, Whiskey891 said:

 

How much did it raise the front end and how long did it take to install? Was it difficult?

Edited October 19, 2020 by LKGRenegade22

[Lance Driskell]

On 5/26/2020 at 6:21 PM, EXSlider400 said:

No. The spacer is less than 1/2” thick. It is not a 1:1 ratio. But I only used a bottom set and I was thinking about adding a 1/2” lift top set. Honestly I probably won’t though...not a high priority right now. These spacers are just a simple metal plate so don’t over think it. All spacers lift more than they are thick due to suspension geometry. 

would you happen to have a link to this spacer?