Jump to content

Recommended Posts

Posted

My 2010 Yukon Denali seems to have a gas tank problem.  I can fill it as fast as I want to so it's not a venting problem. My problem is that when the gauge reads 3/4 tank I can only put in 4 gallons (15 liters) at 1/2 tank it takes 8 gallons (30 liters) and down to a 1/4 tank only takes 12 Gallons (45 Liters) to fill it.  I'm afraid to run it any lower due to the possibility of burning out the fuel pump, if it's not covered with gas. Everything I read says it should be a 23 gallon (90 liter) tank. I'm forever stopping to fill it up. I have measured the tank, it is 48" X 17" X 7".. that means it should hold the 23 gallons or 93 liters.  BUT IT DOESN"T.  The way the gas gauge reads max will be 15 gallons or 60 liters. The gas gauge reading  to fill up ratio never varies so I don't think its a faulty gauge.  Anyone have suggestions or have dealt with this problem?? 

  • Like 1
Posted

Sounds like the fuel sending units level sensor is not working correctly if it's reading that far off.

 

The only real way to test it is to drop the tank so you can pull the pump. Then if you had two people you could move the float up and down to see how it displays on the dash.

 

It's really hard to overheat the pump because it's a returnless fuel system. The fuel that does not get used gets dumped straight back into the fuel bucket in a never ending cycle so the pump always has cool fuel around it.

  • Like 1
Posted

To: Senior Enthusiast,  Thankyou for the info, I will have to drop the tank, I'd say that i'll let you know, but I just had it grease under coated, so I won't be doing that til next spring.  DCoop

Posted

...well, you can kill the pump by running the tank dry. I think that's what the O.P. is concerned with, that he isn't sure how "empty" he can get the tank, based on the gauge, without actually running it dry.

 

Ideally, you'd want to use a scan tool to get the readings that the bcm gets, as well as command the fuel level setting at the bcm to see how accurate the gauge matches what the bcm says it should be, so you at least know if the problem is between the fuel pump and the bcm, or the bcm and the gauge.

  • Like 1
Posted
On 10/5/2020 at 4:22 PM, DCoop said:

My 2010 Yukon Denali seems to have a gas tank problem.  I can fill it as fast as I want to so it's not a venting problem. My problem is that when the gauge reads 3/4 tank I can only put in 4 gallons (15 liters) at 1/2 tank it takes 8 gallons (30 liters) and down to a 1/4 tank only takes 12 Gallons (45 Liters) to fill it.  I'm afraid to run it any lower due to the possibility of burning out the fuel pump, if it's not covered with gas. Everything I read says it should be a 23 gallon (90 liter) tank. I'm forever stopping to fill it up. I have measured the tank, it is 48" X 17" X 7".. that means it should hold the 23 gallons or 93 liters.  BUT IT DOESN"T.  The way the gas gauge reads max will be 15 gallons or 60 liters. The gas gauge reading  to fill up ratio never varies so I don't think its a faulty gauge.  Anyone have suggestions or have dealt with this problem?? 

Your tank has a 26 gallon capacity.

 

When the tank is on:

 

E = 0-13% fuel remaining or 0-3.1 gallons (2.5V or 197-250 ohms)

 

1/4 = 30-35% fuel remaining or 8.7 gallons (2.2V or 150-190 ohms)

 

1/2 = 50-55% fuel remaining or 13.5 gallons (1.6V or 118-140 ohms)

 

3/4 = 72-78% fuel remaining or 19.7 gallons (1.25V or 83-110 ohms)

 

F = 88-100% or 24.5 to 25.9 gallons (1.0V or 40-66 ohms)

 

Low Fuel Indicator On = 11-17% or 4.3 gallons (2.4V or 208-218 ohms)

 

Low Fuel Indicator Off = 14-25% or 5 gallons (2.3V or 195-206 ohms)

 

On a normal system, when the light comes on you should be able to take on 21-22 gallons of fuel.  In normal city driving a Denali like yours should average about 14 MPG and go about 300 miles until the light comes on.  Another 100 miles or so for an all highway mileage trip.

 

In my older GM cars, they would stay on full forever and then swing over towards empty.  On my 2009, the needle moves off of full quickly and once down near empty stays at 11% for 50-100 or more miles.  My tank is 31.5 gallons and it has never taken more than 29.76 gallons and the average fill once the light comes on is 26 gallons.

 

So how far are you travelling between refueling events?  Have you run it down to the light and then filled it up shortly after?  If so, how much fuel did she take on?

Posted

Thankyou for the info. I have never let the light come on as I'm afraid of burning out the fuel pump. My gas mileage sucks as I am usually pulling my car trailer with my antique truck on it to car shows. When not towing, a 40 mile trip is about 3 gallons.  With the 6.2 L engine I don't expect much better, but is great for towing.  

Posted

to Senior Enthusiast.  I think your idea will be the easiest and cheapest to start with. It's off to the shop for a complete scan and set up. DCoop..  

Posted
1 hour ago, DCoop said:

Thankyou for the info. I have never let the light come on as I'm afraid of burning out the fuel pump. My gas mileage sucks as I am usually pulling my car trailer with my antique truck on it to car shows. When not towing, a 40 mile trip is about 3 gallons.  With the 6.2 L engine I don't expect much better, but is great for towing.  

You're not going to hurt your fuel pump by refueling when the light comes on, there is still plenty of fuel on board for that.  At 13 MPG you can still easily attain 275 miles per tank and if towing, you're getting what, about 8-9 MPGs?  That's about 175 miles per tank.

Posted

Drive slower and the 6.2 can easily do 19-20mpg on the freeway. If you get 13-14mpg when not towing maybe you have the heaviest foot and go about 90mph everywhere.

 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,881
    Total Members
    8,960
    Most Online
    tararebecca
    Newest Member
    tararebecca
    Joined
  • Who's Online   2 Members, 0 Anonymous, 534 Guests (See full list)

  • Latest Articles

  • Posts

    • I agree, simplicity and reliability matter more as vehicles get more complicated. A V8 work truck option with fewer electronic features and a stronger warranty would definitely appeal to a lot of buyers who use their trucks for real work. Customizing it with trusted outfitters is often the best way to get exactly what you need.webcrimsNY
    • I’ve heard similar complaints from newer vehicles where the factory “premium” systems don’t always live up to expectations. A good installer should be able to improve the sound without turning it into a bass-heavy setup. I’d look into upgrading the front speakers, adding a quality DSP amplifier, and possibly improving sound deadening first—those changes usually make a much bigger difference than just adding a subwoofer. Hopefully someone local can recommend a reputable installer in the Las Vegas/St. George area.
    • Do you remember that Harley Davidson was more successful (solvent) when it produced about 60% of the market demand (by design) and forced wait times of up to three years? Even when your turn came around it was, "Take what we are giving you or move to the back of the line and start over". HUGE markup's were 'normalized' and dealer killed. 40% markup and no floor plan? What's not to love? Greed will kill them yet. They have surplus production and customer base is tanking. And still they think nosebleed pricing will work.  
    • The engine was done as part of the 6.2 recall?   You'd have to see if your VIN also has the 6.2 engine special coverage on it.  Coverage number is N252494003.  If you have this, your engine is covered under this and NOT the GM replacement part engine warranty which is 3yr/100k from the date of install.  The 3yr/100k mi warranty is in effect for non warranty purchases.     This is not any different if it was replaced under warranty without a recall or special coverage.  So if you had a 5.3 and it popped at 3 years in at 50,000mi during the 5yr/60k powertrain, the replacement engine would not get the 3yr/100k, and instead gets the remainder of the 5yr/60k as coverage.     So N252494003 gives 10 years or 150,000mi of coverage, which ever comes first, starting at the vehicle in service date.  So if your in service date is 01/01/2022, N252494003 gives you special coverage of the engine until 01/01/2032 or 150,000mi, whichever comes first.  So if your start date was 01/01/2022, you'd have left 5 years and 4 months (lets round to august 1st), or 62,000mi left of coverage.   So you need to know your in service date to know how much coverage is left.  
    • Okiee dokie there bud, way to take things to the extreme.   I guess you missed the whole point and take things way to serious. I installed different EV6 style injectors that just so happen to be larger in my car running the same LQ4 engine and with a better spray pattern than the stock style injectors and I noticed no difference in the idle quality. Kinda was my round about way of saying that even if you put the same size but better style injectors in your truck, you will likely see the same thing.    I'm sure you're great to have conversations with in person if that's how you act through a keyboard. One little things sets you off and now I guess my dick is all up in your face.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...