Jump to content

Recommended Posts

Posted

Hi Team, 

 

I just bought a 23'  3.0 Duramax Silverado LT Z71 this past October.  I have had frequent issues and had the truck in the shop going on 3x inside of 1500 miles for  "Service Emissions System". I ran the trouble code and it came back with P2B97: Exhaust pressure control valve A position exceeded learning limit. This light and message goes on and turns itself off intermittently, but warns me that my max speed will be limitedOn the second time time in the shop, they replaced the part FP: 400009243- SPAC C04108161, an part described as Actuator 3.67.

 

The trouble code/check engine light popped up in the following sequence.

11/2 On- within the first tank of gas from the dealer.

11/6 turned off, took to dealer and explained the code found. Dealer kept a few days, but told me I could pick up and drive because they didn't have the part.

11/11 light on again

11/16 took to dealer for repair, light on at time of drop off.

11/17 got the truck back

11/18, light goes on again, same message

11/20, light turns itself off

11/30, light goes on again... time to take back to the dealership...

 

My concern here is I am in CA and want to own this truck for a long time, but this is the type of issue that would fail a smog test when I have to renew registration down the line and I will then be stuck with the repairs.

 

I don't want a lemon, but this is getting ridiculous and I have some remorse over buying the truck at this point.

 

Any feedback is appreciated.

 

 

20231130_205324.jpg

Screenshot 2023-11-30 213814.png

20231118_131103.jpg

Posted

I haven't heard anyone else with the problem. I have the 2023 Sierra with the same engine. Close to 2,000 miles. No issues. You might consider contacting GM customer service and file a complaint. Send them the same photos along with the dealer name. Hold their feet to the fire. 

Posted

Keep at them.

Eventually they'll get far enough down the diagnostic tree to get it corrected.

 

I follow several forums that follow 6.6 and 3.0 dmax trucks.

What you're describing is not something I recall reading about before. 

 

If you push the onstar button when it has the cel they can get the code

Posted

Thanks guys. I appreciate the comments and the feedback. Makes me feel like I am not on an island over here. The light turned off again this afternoon 🤦‍♂️- Go figure. I think it is somehow tied to the drive cycle. We will see. Taking it to the dealership again tomorrow....

Posted

OP, Just to give you some hope. I had an emissions issue within the first 7,500 miles (If I'm remembering correctly).

 

The dealer replaced a NOX sensor and a CAT.

 

Currently just under 50K miles and have had zero issues since.

Posted
On 12/1/2023 at 8:48 AM, Rick Davenport said:

There is an ECM update for the 2023 3.0. It covers a lot of codes. Take it in to the dealer and see if it applies. Here's the info on the TSB:

https://www.gm-trucks.com/critical-fix-released-for-silverado-sierra-3-0l-duramax-with-check-engine-lightfrom working in the diesel industry on heavy duty trucks, this was the first thing that comes to mind is a calibration problem( ecm or emission control module update. I opened prodemand and read this bulletin as this sounds like a solution to this problem.when you go back to the dealership take this bulletin number with or print it of ( the TSB listed in this article) ask for this update to be installed. Per GM training the bulletin should have been the first thing done. I think this might just solve your problem. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   0 Members, 0 Anonymous, 1,661 Guests (See full list)

    • There are no registered users currently online
  • Latest Articles

  • Posts

    • I’m definitely interested to hear the end result here. 
    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...