2006 Silverado HVAC sensor location in dashboard

[MAC88]

Having trouble with my AC evaporator freezing up. Last year, all components, except the evaporator & hvac control module were replace replaced. Evaporator has been tested, flushed and cleaned, and the fins have been cleaned.  Drain is working properly as well. From all the research I’ve done it. Is this small sensor. 
 

My vin# 1GCHK23U06F239688

 

Instrument Panel Air Duct Air Temperature Sensor part # 12160947 

 

my question is where is it located in the HVAC ducting I have looked on GM parts. I’ve gone to the dealer and nobody can give me a schematic. I question if this was the right part, but my dealer assured me based on my VIN it was. I have been told it’s accessible without removing a dashboard and I’ve also been told I need to remove the dash to replace it.
 

Looking to find the location so I can swap the sensor out before having to dig  further. 

[davester]

look for it's replacement procedure on charm.li or alldata.com

 

For my '12, the sensor is pressed into the evaporator directly, and to replace it w/o pulling the whole hvac box, you cut a hole in a specific spot to gain access to it, and then plug the hole afterwards.

[Jsdirt]

I don't recall ever dealing with one on an '06 and back. It may not even exist on that. I can't remember for sure.

 

Any kind of ice in or after the evaporator is normally due to low charge with both a clutch-cycling orifice tube system, and a TXV system.