Jump to content

New Baby Arrived!


Recommended Posts

Posted

All these pics of new trucks lately was more than I could bear! So here's my latest contribution to the truck accessories world! Arrived home on July 1st.... 50couple miles mostly put on by me during test drives. Love that Sheer Silver with the Z-71 Appearance Package. Love me those light to neutral colors too that don't show dirt too bad! Got the vent visors and big Bowtie mudflaps (due to places that I hunt and gravel roads). Ordering a matching cap this week to, as my Dad used to say, "keep the honest people from stealing stuff" out of the bed. A little GM auto start from the dealer and it'll be done. Already have a bed mat and nice floor mats from a prior truck.

 

Leveling it with possibly some bigger tires are down the road. I'm also thinking about 20"ish Magnaflow muffler for a little rumble that won't be too annoying in 4 cyl. mode. Then again, with the terrain where I live, that 5.3 doesn't spend a lot of time in 4 cyl.

 

2011-07-04132559.jpg

 

2011-07-09115127.jpg

Posted

Nice, Gotta love that Z71 Appearance front end!

 

Do you have a PN for the flaps you have? Did you have to drill any holes?

 

Congrats and enjoy!

Posted

Nice truck...congratulations. The appearance package looks awesome in silver.

 

:rollin:

Posted
Nice, Gotta love that Z71 Appearance front end!

 

Do you have a PN for the flaps you have? Did you have to drill any holes?

 

Congrats and enjoy!

 

Thanks Nuke and yes Sir I gotta part number for you and others that have inquired and you're not gonna believe it!

 

PN is: 0008113410507 They are made by Plasticolor and are from....get ready....Walmart! Check their website and enter that PN. They're sold in pairs and I got them shipped to my shack for $49.72 (2 pairs). I think the factory GM molded flaps look good but their coverage is a joke. If I'm putting flaps on, I want them to do a good job. Yes I had to drill some holes (hardware is provided) but I was able to mount them lower than the GM molded ones. Therefore, I get better protection. I wasn't overly crazy about the yellowish Bowtie but they have grown on me (being a Steelers fan :rollin: ).

 

Here's the link: http://www.walmart.com/search/search-ng.do...ch_constraint=0

Posted
Nice, Gotta love that Z71 Appearance front end!

 

Do you have a PN for the flaps you have? Did you have to drill any holes?

 

Congrats and enjoy!

 

Thanks Nuke and yes Sir I gotta part number for you and others that have inquired and you're not gonna believe it!

 

PN is: 0008113410507 They are made by Plasticolor and are from....get ready....Walmart! Check their website and enter that PN. They're sold in pairs and I got them shipped to my shack for $49.72 (2 pairs). I think the factory GM molded flaps look good but their coverage is a joke. If I'm putting flaps on, I want them to do a good job. Yes I had to drill some holes (hardware is provided) but I was able to mount them lower than the GM molded ones. Therefore, I get better protection. I wasn't overly crazy about the yellowish Bowtie but they have grown on me (being a Steelers fan :rollin: ).

 

Here's the link: http://www.walmart.com/search/search-ng.do...ch_constraint=0

 

 

Thanks, I just searched and found plain as well as ones with a RED Bowtie on Amazon

http://www.amazon.com/dp/B0002NIJRG/ref=as...ASIN=B0002NIJRG

 

Go STEELERS!!! Hope that lockout ends soon!

Posted

Beautiful. Very sharp ride.

 

You may not have to be concerned with the 4 cylinder drone. What rear end gears do you have and does it have the 6 spd tranny? My 11' with 3.08 gears and 6 speed tranny spends almost no time in 4 cyl mode, usually for only short stretches going down hill.

 

(Nice bows in the background too!)

Posted
Beautiful. Very sharp ride.

 

You may not have to be concerned with the 4 cylinder drone. What rear end gears do you have and does it have the 6 spd tranny? My 11' with 3.08 gears and 6 speed tranny spends almost no time in 4 cyl mode, usually for only short stretches going down hill.

 

(Nice bows in the background too!)

 

Truck has 3.42 gears with the 6 speed. And from what I've seen so far it does not seem to run in 4 cyl mode as much as the '07 I had.

 

And the bows....that one to the left of the 3rd brake light is my "Ford;" a GT500....okay it's an Elite..... :banghead:

Posted

Puurrrdy truck. I'm not much of a fan of the z71 appearance package but it looks good on that silver!

 

..but I'm not so sure about the steelers :banghead:

Posted

kinda looks like mine :banghead: by the way mine has the 2" RC level kit & 3" rear blocks

 

Nice truck!

DSC05041.JPG

DSC05041.JPG

DSC05041.JPG

DSC05041.JPG

Posted

Thanks fellas...and Ryan, I have noticed your signature line pic for a long time with those two silver beauties! That truck is standing tall with that leveling kit!!!

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.3k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,710
    Total Members
    8,960
    Most Online
    90Nine4One
    Newest Member
    90Nine4One
    Joined
  • Who's Online   1 Member, 0 Anonymous, 417 Guests (See full list)

×
×
  • Create New...