Removing a small lowering kit and going back to stock

[Ian-NH]

I bought a truck recently from a local dealership that I found out belonged to a member here. It's a 2014 2wd RCSB, and it looks like the previous owner installed a Bell Tech 2/3 drop, Bell Tech part # 984.

 

After driving it around our less than perfect roads up here in NH, I've decided that maybe a lowered truck and 22"s aren't the best idea. I'd like to put it back to stock and then level it. It looks like the 2/3 drop is spindles up front and shackles for the rear, plus removing the block in the rear. I'm sure I can find some original shackles and a rear block, but what about the spindles? Do I have to go back to Chevy for this?

 

I looked in the "Level Kit" thread but didn't see much 2wd stuff, Do most people lower 2wd trucks?

[victorsdaddy]

Should be able to find some spindles pretty ez.

 

I leveled the rear of 2wd. It was just shackles. No problems after a 1000 miles so far.

 

A co-worker leveled the front of his all terrain and tore a boot in front, After about 9 months

 

Sent from my Nexus 6P using Tapatalk

[Dub1796]

Too bad youre far away, I would trade you my stock parts