Jump to content

Recommended Posts

Posted

They do! Really nice kit too, I welded mine instead of drilling and using the supplied bolts/spacers because honestly, once you cut the frame you won’t ever be able to remove the c-notch so why waste time drilling and bolting. Once you cut the frame the notch should stay in there forever. 

Posted
2 minutes ago, bwright2112 said:

They do! Really nice kit too, I welded mine instead of drilling and using the supplied bolts/spacers because honestly, once you cut the frame you won’t ever be able to remove the c-notch so why waste time drilling and bolting. Once you cut the frame the notch should stay in there forever. 

Pictures and part number please. I bought an underbed notch but I havent installed it yes. Because it would be easier to reverse a regular c notch than an underbed 

Posted
1 minute ago, bwright2112 said:

Yea this one comes with C-Notch and crossmember notch for rear end (“pumpkin”)

 

Part #6524

6DE6F34E-8CC3-4CBA-BE3F-039311463D9A.jpeg

I wonder why it doesnt state for 16 17 when it's the same frame 

Posted

Not sure, I’m sure you could call and ask but I am willing to be they just haven’t tried it yet. Might be able to get lucky and be their tester and get it cheap and/or free install

  • 1 month later...
Posted
On ‎1‎/‎23‎/‎2017 at 5:23 PM, bakerrr said:

I run 305/40/22 on a 4/7 and rub on big dips and when in full lock

64bc8bde2de38824b6140db83f73cb35.jpg

Similar for me. Same wheels even but I run a 285/40/22 on the front and no rubbing

Posted

Stock 285/45/22 on a 4/7 drop.  Lock up front for tight turns.  Going to be raising it up to 2/4 soon and adding 1.5" spacers.  Looking for that street truck look and want to be able to drive it without steering limitations.

 

For the guys running 305/40/22s on Chevy OEM rims - where did you find tires that size that fit on the 9" wide OEM rims?

Cats Rally Lower2.jpg

Cats Rally Lower1.jpg

  • 3 months later...
Posted
On 2017-01-23 at 7:23 PM, bakerrr said:

I run 305/40/22 on a 4/7 and rub on big dips and when in full lock

64bc8bde2de38824b6140db83f73cb35.jpg

Dear god that’s sexy ?

  • 11 months later...
Posted
On 8/26/2017 at 10:50 PM, qwank said:

I'm running the stock 285/45R22 because I got them for free. I'l most likely go with 305/40R22 next time around.

 

post-133504-0-24554600-1503802176_thumb.jpg

 

post-133504-0-24554600-1503802176_thumb.jpg

post-133504-0-24554600-1503802176_thumb.jpg

post-133504-0-24554600-1503802176_thumb.jpg

What about a 285 22 up front and the 305 24 in the rear. Would be sporty and you could drop the rear a extra I ch to level this out.

Posted
On 1/25/2017 at 12:27 AM, Marv88 said:

Every time I see the great look as well as photography of this truck I say to myself "this bad boy should be in a Chevrolet commercial!"

Please let us knowwhere u got these wheels.

And full specs. Size and offsets

 

Posted
On 7/24/2018 at 10:19 AM, K_Sevy said:

Here's my 2015 4wd on 285/45/22 with a Belltech 3/4 drop. 

20180721_203457.jpg

Great looking truck!!!

  • 1 year later...
Posted
On 1/24/2017 at 7:28 PM, 14GMC14 said:

db421b7f26d0d652bc2080d3e192cf97.jpg

 

275/40R22 Continental 4/7 Belltech

 

 

Sent from my iPhone using Tapatalk

Is that a stock Borla exhaust or modified?

  • 3 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   0 Members, 0 Anonymous, 1,552 Guests (See full list)

    • There are no registered users currently online

  • Latest Articles

  • Posts

    • I’m definitely interested to hear the end result here. 
    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...