Borla Drivers Side Pipe/Tip Dropping

[BSME1115]

My drivers side exhaust pipe keeps dropping on a duel exit Borla exhaust. I can tell it is from the middle pipe section moving because it does not have a hanger on it to hold it in place. I tried zip-tying in several different ways and it continues to drop/slip. I called Borla and they told me that the pipes are likely too smooth and I should hit them with sand paper to rough them up so they don't slip??

 

Has anyone else had this issue??

[SilveradoSaver]

This is the reason I didn't buy a duel exit out the rear and opted for the original side-exit Borla. I've seen too many aftermarket duel rear exit exhausts that are not even and it would drive me nuts.

[OmniCamaro]

The pipe falls to the ground? What is your meaning of "dropping"?

I just installed my Borla ATAK cat-back so I'm wondering what to be on the lookout for.

 

 

Sent from my iPad using Tapatalk

[OmniCamaro]

They make exhaust pipe "sealant", maybe that will do the trick?

 

 

Sent from my iPad using Tapatalk

[BSME1115]

The pipe falls to the ground? What is your meaning of "dropping"?

I just installed my Borla ATAK cat-back so I'm wondering what to be on the lookout for.

 

 

Sent from my iPad using Tapatalk

It drops 2-3 inches