ABS rear reluctor ring in the housing 08 Z71

[Off_Trail]

Is there a special tool needed to install the ABS reluctor ring into the housing. I'm changing my rear axle bearings and one of mins is damaged.

[Off_Trail]

I guess nobody knows or there isn't a specific tool. If anyone is interested here was my solution. I took a race installer and turned down the OD to slightly smaller than the reluctor ring. I used the flat side of the race installer to drive it into the housing. I'm sure there are other options but I couldn't find anything the right size.

[Jsdirt]

That's exactly what I would've done. Whenever I can't find, or don't want to spend the money on a special tool, I make my own. As long as it gets the job done, nothing else matters. 

[K Taylor]

How did you get the reluctor ring out? Did you use a slide hammer with a bearing puller?