Lowering 1” block on a 2020 trail boss

[Julio13]

Was wondering just replaced the 2” rear block on a trail boss with a 1”. I read on forum that on a lift kit you will not be able to use the 4x4 just wondering if it would be the same idea with lowering it. If anybody that has done this has used the 4x4 after the 1” install any info would be greatly appreciated.

 

 

Sent from my iPhone using Tapatalk

[Jav_eee]

Rear block? If so, don’t worry about that warning. That’s only for the front because CV angles get to be too much.


Sent from my iPhone using Tapatalk Pro

[Julio13]

Rear block? If so, don’t worry about that warning. That’s only for the front because CV angles get to be too much.


Sent from my iPhone using Tapatalk Pro

Yes rear block ok sounds good thanks again


Sent from my iPhone using Tapatalk

[Jav_eee]

No problem


Sent from my iPhone using Tapatalk Pro

[TheTicketTX]

Why buy trail boss if you’re going to lower it?!

[Julio13]

Why buy trail boss if you’re going to lower it?!

I like the leveled look don’t really like trucks with that rake they come with


Sent from my iPhone using Tapatalk

[JR09country]

Agreed. Id rather lower the rear than stretch the front another inch, especially if you dont want to do UCAs.

Sent from my ONEPLUS A6013 using Tapatalk

[Jav_eee]

Why buy trail boss if you’re going to lower it?!

Because CV angles.


Sent from my iPhone using Tapatalk Pro

[ahilton02]

On 4/2/2020 at 3:54 PM, Julio13 said:

 

Was wondering just replaced the 2” rear block on a trail boss with a 1”. I read on forum that on a lift kit you will not be able to use the 4x4 just wondering if it would be the same idea with lowering it. If anybody that has done this has used the 4x4 after the 1” install any info would be greatly appreciated.

 

 

Sent from my iPhone using Tapatalk

 

Did you end up installing to 1” blocks? If so, have you had any trouble? And we’re the blocks you ordered flat or tapered?