2020 Denali Aux gauges on pillar?

[hmarv347]

anyone running a pillar pod with auxiliary gauges? Looking for a pillar pod and boost gauge, egt, etc

Edited April 24, 2020 by hmarv347

[sdelam]

Not a pillar set up but....replaces top vent/ speaker panel. Blockhead8 on facebook

 

 

 

[hmarv347]

Thanks, I've seen the banks gauges but it looks like they are tied to a programmer which im not sure if its detected that a program was loaded at one time. Warranty issues. My truck only has 1200 miles on it. 

[sdelam]

On 4/24/2020 at 3:57 PM, hmarv347 said:

Thanks, I've seen the banks gauges but it looks like they are tied to a programmer which im not sure if its detected that a program was loaded at one time. Warranty issues. My truck only has 1200 miles on it. 

If you dont want the Derringer tuner you can get just the gauge. It plugs into the OBD II port and acts like a code reader only. Doesnt change any engine/transmission paremeters, just reads them. 

[ApertureX]

On 4/23/2020 at 9:53 PM, hmarv347 said:

anyone running a pillar pod with auxiliary gauges? Looking for a pillar pod and boost gauge, egt, etc

Coming Soon:
https://bankspower.com/products/63369-63379-idash-stealth-pods-22-gm?variant=42150425821381

[Kerry Pulaski]

Thanks very much for this link to the Banks site.  They are really on top of the '24 HD release. I looked at the available data monitor capability of the iDash, and also data capture of the optional SD card if you want. Amazing !!

One '24 GMC HD Denali Ult. owner just posted a pic of his A-Pillar gauge installed. Looks great !!

Said only regret was not getting the Dual Pod A-Pillar gauge mount kit......I agree. That is the way I'm going, with the available data to see and choose, two displays are the way to go.

Very disappointed with the new digital dash display critical engine & electrical values to monitor in my '24 HD.

Min/Max Bar Graph with no numeric value overlay ?  Really ?????   What are Gm Eng's. thinking. 

Same with my posts on lack of cabin lighting. Again xxxx'd me off last night, trying to see my running boards getting out.

Almost done adding those LED's.

 

Like the phone & home app for my Xfinity home alarm, had a device battery voltage condition numeric value display for all sensors.

New software update..........., now only shows "Good  & "Replace". ???  I asked a Xfininty Tech why  ??

Said "too confusing" for most home owners.  This World is trying to Dumb Us All Down. I say "Can't Fix Stupid", but let us with some I.Q. HAVE a choice.