Lift Options for 2020 Denali HD

[Derek Howard]

I’m picking up my truck either tomorrow or next week. When I was shopping, I found a ram 2500 with the Fabtech 5” and the Dirt Logic 4.0 shocks. I really liked the setup. Are there any big reservoir shock lift kits available 5” or more? I see Fabtech lists a 5” coming soon, but haven’t found much in search.

[gSwift]

Definitely interested in this as well. Just picked up a 2500 AT4 and plan on doing a 7” plus lift.

[Derek Howard]

I ended up doing the BDS 6.5”, but it ended up higher. Measurements at front fender shows it went up 7.75”. Here’s a couple of pics on factory tires. 

Edited August 17, 2020 by Derek Howard
Replies

[Derek Howard]

[cNate]

The BDS kit is great. What size tires and rims you planning to run? 37s would look great! Looks funny with the stock tires on there now!


Sent from my iPhone using Tapatalk

[Derek Howard]

7 minutes ago, cNate said:

The BDS kit is great. What size tires and rims you planning to run? 37s would look great! Looks funny with the stock tires on there now!


Sent from my iPhone using Tapatalk

Probably unpopular here, but JTX Forged is building me a set of 26x12 and we are going to put 37x13.50r26’s on them. My truck is a tow pig and doesn’t really go off-road. Dirt road here and there, but that’s it.

Edited September 6, 2020 by Derek Howard

[cNate]

Holy ******. Those are going to be huge rims. I had a 6” kit on my old truck. If I did it to this one (2020 AT4 HD) then I’d probably go 37s on 20s. I do take my truck off road though: sand, snow, dirt, etc... the rims are already damaged and I’ve had the truck less than a year.

 

Post a pic when it’s done!

 

 

Sent from my iPhone using Tapatalk

[gSwift]

On 9/6/2020 at 12:57 AM, Derek Howard said:

Probably unpopular here, but JTX Forged is building me a set of 26x12 and we are going to put 37x13.50r26’s on them. My truck is a tow pig and doesn’t really go off-road. Dirt road here and there, but that’s it.

I've kinda been leaning towards the all black JTX Forged Chamber wheel for my AT4...Just not that big lol. I might would consider 24's, but most likely i'll be doing a 22x12 on 37's

[Derek Howard]

On 9/7/2020 at 9:28 PM, gSwift said:

I've kinda been leaning towards the all black JTX Forged Chamber wheel for my AT4...Just not that big lol. I might would consider 24's, but most likely i'll be doing a 22x12 on 37's

Finally put them on.

 

 

[gSwift]

3 hours ago, Derek Howard said:

Finally put them on.

 

 

That turned out great! I like the big wheel look but not sure I could go 26's. I ended up just ordering a 3" level and 37's for now, but i'm not sure it will satisfy me. haha  I'll probably end up redoing it all in a year and do a huge lift and 24's