LED Tail Light Wiring

[kalooch]

I replaced all the rear bulbs with LED however I am getting hyperflash. I have load resistors but I'm not sure which wires I'm supposed to splice into. Any help would be greatly appreciated, thanks! 2019 Silverado btw

[sharkeysierra]

The power wire

[kalooch]

13 minutes ago, sharkeysierra said:

The power wire

which is what color? i need the signal wire color and ground. ground is black obv but there are 2 black wires

[jnissen]

Or buy the correct LED bulbs with loads built in. That’s the easiest.

[sharkeysierra]

3 hours ago, kalooch said:

which is what color? i need the signal wire color and ground. ground is black obv but there are 2 black wires

Grab a circuit tester and poke at the wires.. 

[SgtDrew]

On 9/27/2020 at 4:14 PM, kalooch said:

I replaced all the rear bulbs with LED however I am getting hyperflash. I have load resistors but I'm not sure which wires I'm supposed to splice into. Any help would be greatly appreciated, thanks! 2019 Silverado btw

 

On 9/27/2020 at 4:54 PM, kalooch said:

which is what color? i need the signal wire color and ground. ground is black obv but there are 2 black wires

Connect a load resistor to the green wire and the lower black wire for the upper light.  For the bottom light you’ll want to connect your resistor to the bottom green and the bottom black.  This should work for you.   Get a good connection with your splicers.  You’ll need 4 resistors total.  This worked for me on my 21 Silverado LT