For anyone that had warranty leaf spring isolators installed, did it fix the issue?

[Jav_eee]

Worked for me, only been two weeks and about 1,000 miles but I'm very pleased!
 

Good to hear! So tired of this EMBARRASSING noise haha


Sent from my iPhone using Tapatalk Pro

[Spyderwebb]

Just now, Jav_eee said:

 

Good to hear! So tired of this EMBARRASSING noise haha


Sent from my iPhone using Tapatalk Pro

 

This is the TSB you'll want them to perform:

https://static.nhtsa.gov/odi/tsbs/2019/MC-10165102-9999.pdf

 

Edited October 16, 2020 by Spyderwebb

[Jav_eee]

This is the TSB you'll want them to perform:
https://static.nhtsa.gov/odi/tsbs/2019/MC-10165102-9999.pdf
 

Well she said she knew exactly how to fix it and that she knew it was those pads so hopefully that’s the one they do.


Sent from my iPhone using Tapatalk Pro

[king kong]

On 10/7/2020 at 4:25 PM, BlancoSilverado said:

I would like to know too, I checked mine a few weeks ago and it was not to the factory spec( min 140 degrees off).

 

Does anyone know what they should be if the truck has the z71?  

My truck is making the noise and i checked them they were at 80 lb ft so i made them 85 lb ft but i am wondering if i could go higher. For the z71 the socket used for the bolt is 13/16 or 21mm. I tried looking everywhere but i am unable to locate it.

[AG]

Bought a 1/8 inch recycled rubber sheet from Amazon for less than $3 and cut into strips as wide as the leaf springs. Slid into the gap and pried open the leaf to get the rubber strip closest to  connection to the other leaf.  Zip tied the strip to the spring and it was like a light switch.  No noise. No clunk.