Jump to content

weird parasitic draw on battery EDIT SOLVED

brian barton
 Share

Recommended Posts

brian barton New Member

brian barton

Posted
Posted (edited)

as it says i have a weird parasitic draw on a 2000 chevy silverado 1500 with 5.3L  battery when shut off.   i have done the parasitic draw tests 3 times now. twice with a multi-meter and once with a test light.  it shows a draw of 11.5-12a while shut off key removed doors closed no lights or accessories running.
removed ground wires *(2 heavy gauge ground wires) and tested with multi-meter. while watching the meter every single fuse was pulled and reinserted with no difference in draw. all relays were also removed and reinserted also with no difference in draw load.
my brother and i are both industrial electricians but DC is wildly different than AC.
the 130A alternator was put new today long with a new battery.

the only thing i can think of at this point is possibly a faulty ignition switch that is passing current to something... but once again i've checked all fuses and relays and nothing changes anything..

any ideas would be appreciated.

Edited by brian barton
Charles_Colfax Enthusiast

Charles_Colfax

Posted
Posted

Following.
I'm chasing one on mine too.
Have mine narrowed down to something in the radio wiring.
These trucks are brutal with electrical gremlins.
I've had bizarre ground issues... That's what I've ended up finding a couple times.

Sent from my HD1907 using Tapatalk

riverbanks Senior Enthusiast

riverbanks

Posted
Posted

Sometimes you have to disconnect every module,one by one,there are a lot of them,radio,yup,it helps to check codes "u"codes,might narrow it down faster

kickass audio Enthusiast

kickass audio

Posted
Posted

is your radio aftermarket or factory? I know some aftermarket units that have GM chime adapters or steering wheel controls have problems where they draw a ton of power when they go bad. If you have an aftermarket radio look for a tiny black box usually buried in the dash or behind the radio, if you have it, disconnect it and check your draw level.

 

Do you also have any huge corrosion on the trailer connector at the rear that may be causing a short?

brian barton New Member

brian barton

Posted
  • Author
Posted
1 hour ago, kickass audio said:

is your radio aftermarket or factory? I know some aftermarket units that have GM chime adapters or steering wheel controls have problems where they draw a ton of power when they go bad. If you have an aftermarket radio look for a tiny black box usually buried in the dash or behind the radio, if you have it, disconnect it and check your draw level.

 

Do you also have any huge corrosion on the trailer connector at the rear that may be causing a short?

aftermarket radio but no steering wheel controls are anything of the sort...  even went as far as unplugging the entire fuse box in the dash... still nothing stopped the draw...

Charles_Colfax Enthusiast

Charles_Colfax

Posted
Posted
Sometimes you have to disconnect every module,one by one,there are a lot of them,radio,yup,it helps to check codes "u"codes,might narrow it down faster
What are "u" codes?

Sent from my HD1907 using Tapatalk

Charles_Colfax Enthusiast

Charles_Colfax

Posted
Posted
is your radio aftermarket or factory? I know some aftermarket units that have GM chime adapters or steering wheel controls have problems where they draw a ton of power when they go bad. If you have an aftermarket radio look for a tiny black box usually buried in the dash or behind the radio, if you have it, disconnect it and check your draw level.
 
Do you also have any huge corrosion on the trailer connector at the rear that may be causing a short?
Aftermarket here too.
I've got all the adapters for steering wheel controls, factory Bose amp, and integrated satellite radio.

I've got to make some time to pull the dash apart and go thru everything

Sent from my HD1907 using Tapatalk

  • Like 1
brian barton New Member

brian barton

Posted
  • Author
Posted

SOLVED.... the issue was the alternator... the rectifier was faulty and allowing backflow...  *(yayy advance auto budget alternator)

also added 2nd ground cable for good measure... 

  • Like 4
kickass audio Enthusiast

kickass audio

Posted
Posted
4 hours ago, brian barton said:

SOLVED.... the issue was the alternator... the rectifier was faulty and allowing backflow...  *(yayy advance auto budget alternator)

also added 2nd ground cable for good measure... 

Glad you figured it out! Did you run a diode test on the alternator to find that out? I never even considered a possible draw issue on the alt when it's shut down.

  • Like 1
brian barton New Member

brian barton

Posted
  • Author
Posted
42 minutes ago, kickass audio said:

Glad you figured it out! Did you run a diode test on the alternator to find that out? I never even considered a possible draw issue on the alt when it's shut down.

yes...after removal tested it on the countertop tester... it tested bad... installed new one... charged battery completely... checked with amp meter a big fat 0 draw with everything turned off...

i am happy... cause it was scaring me that i'd have to spend more money than the truck is worth...  

  • Like 3
  • 3 weeks later...
Charles_Colfax Enthusiast

Charles_Colfax

Posted
Posted
SOLVED.... the issue was the alternator... the rectifier was faulty and allowing backflow...  *(yayy advance auto budget alternator)

also added 2nd ground cable for good measure... 
Dang. I haven't touched my truck in weeks.
But now may have to look in to this.
It's the original alternator... From 2006, 14 years and 105,000 miles.
Like you, I'll start with pulling the radio fuses first.
I'll pull the battery and fully charge it overnight too.

Sent from my HD1907 using Tapatalk

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • No1UKnow
      Transmission Woes :-(

      By No1UKnow · Posted

      Hello All!   My 2019 Colorado 3.6 LT, 4WD Crew Cab has approximately 77,500 miles and I recently began experiencing the well-known transmission shudder between about 30 and 65 mph. The problem had worsened to the point that I could no longer attribute it to road conditions - and I had decided to bring the truck to the dealer - when recently, I experienced a sudden loss of power while driving at maybe 40 MPH. Several warning lights flashed, the “Check Stabilitrack” message appeared, and the Check Engine, Stabilitrack, and Traction Control icons remained illuminated. The truck regained driving power, but it stayed in a low gear with unusually high RPMs for the speed. (limp mode?) Because I was only about two miles from home, driving slowly, I was able to make it back and run an OBD-II scan, which showed fault codes U0101, P0700, and U0100. My next trip in the truck was to drive it to the dealer the following day. That trip began normally, but after about a mile I experienced another loss of power, along with the same warning lights and the same “Check Stabilitrack” message. As before the truck remained driveable, but again operated at an abnormally high RPM-to-speed ratio and seemed stuck in a single gear. About a mile later, the dashboard lit up once more, this time displaying “Check 4WD.” Soon after that, I arrived at the dealer. I have verified that the truck still has its original factory transmission fluid, which means it has never received the corrective fluid exchange outlined in GM Technical Service Bulletin #18-NA-355.  That was Thursday of last week and I've heard nothing yet from the dealer.    According to Technical Service Bulletin #18-NA-355 and the build date of my truck, my truck should have the newer LV fluid. I've done a little research and read something about a problem with the wiring harness as well.   Anyone have an insights into this situation?  Thank you!!
    • GMCustomerService
      Damaged Left Rear Bumper & Left Rear Quarter Panel - Repair Questions

      By GMCustomerService · Posted

      Having bumper and other body damages can be very frustrating, especially as a result of a parking lot collision/bump. Our team wants to learn more about the damages to your truck so we can look into ways we might be able to help. When you get the chance, please fill out our support form with more details: https://s.gmc.com/support-request . A member of our team will follow up with you as soon as next available. We want to get you enjoying your truck to the fullest again. 
    • PhilB
      Gas Prices

      By PhilB · Posted

      Did you even read this article?   Even the title of the article says "U.S.-Iran Deal Doesn’t Mean a Swift Return of Oil and Gas Flows"   Remember, crude oil prices are based on FUTURE purchases by the oil companies.  Gas prices are based on FUTURE purchases by the station.  This article stated that many of the oil producing nations have to restart their processes to get the oil produced.  Then the oil has to be shipped to wherever.  And it doesn't get there overnight.  And most of that oil is not coming here. Check out this site:  https://afdc.energy.gov/data/10621   A graph will pop up to show where the US imports their oil from.  Notice that there isn't a lot of import from OPEC and Iraq.  Most of the US import comes from Canada. The US oil produces are selling their oil on the open market, which is why the US fuel costs went up.  So you're correct, the US oil companies are going to slow walk the price downward.
    • GMCustomerService
      Tranmission stays in Low

      By GMCustomerService · Posted

      Having codes and an engine light with no hints on what might be causing it is nothing short of frustrating. How long have these concerns been present? We want to know more so we can look into ways we might be able to help you. When you get the chance, please fill out our support form with additional details on your experience so far. A member of our team will follow up with you as soon as next available: https://s.gmc.com/support-request 
    • GMCustomerService
      Defective Brake Pad Wear Sensor?

      By GMCustomerService · Posted

      Knowing the life of your brakes is a highly important status to keep track of. If you suspect your brake sensors need attention, please fill out our support form with additional details on your experience. When did you last take it in for inspection? Our team will follow up with next steps as soon as next available. Please include your username and GM Trucks Forum in the form as well. Support Form: https://s.chevy.com/support-request 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...