Jump to content

Rear end clunking

Kruck88
 Share

Recommended Posts

Kruck88 Enthusiast

Kruck88

Posted
Posted

Searched through some other threads and didn't find anything that matches my symptoms.  It's an 05 Silverado 3500 DRW 4x4.  The only time I notice it is when going slow, as in walking speed, and either barely on the gas or at idle.  It sounds like a solid clunk with about every rotation of the tire.  I've jacked the truck up and ran it on jack stands, no noise.  I've turned the wheels by hand on jack stands, no noise.  I've removed the rear wheels to make sure there wasn't anything trapped.  Crawled under the truck and the u-joints seem fine, even greased them while I was under there.  

 

Next on the list is to pull the hubs to see if maybe something in the parking brake has failed?  Any more suggestions?  It isn't spring related as I know there have been lots of issues around that.  It doesn't seem to get better or worse when I turn.  There is no vibration or noise going down the hwy.  You can't really feel the clunk unless you are really really paying attention and the surface is smooth.  

davester Senior Enthusiast

davester

Posted
Posted

Maybe chock the front wheels and using the engine to spin the rear wheels.  If you know it has an open diff and not a G80, you might also chock one rear wheel and then other other and see if it happens on one particular side (If you have a G80, this is dangerous, as when the relative speed difference makes the G80 lock, then the chocked wheel will suddenly really want to spin).

davester Senior Enthusiast

davester

Posted
Posted

... and there's not much in the parking brakes to make a clunk, short of some part having come loose to roll around inside.

 

If you can't hear a loud clunk doing that test with the engine spinning the wheels, maybe try repeating it, and use a mechanics stethoscope (carefully) to listen to the backside of each hub, and to the diff housing, maybe you can hear something using it.

David89GMC Enthusiast

David89GMC

Posted
Posted

Did you clean the tires of all debris and check them for roundness? I often get what you describe and it's always a rock stuck in the tread, front or rear. Radial ply tires can fail with this symptom.

A clunk on each revolution indicates a wheel or axle related problem. The propeller shaft turns 4 times the speed of the wheels and final drive, so you can disregard that as a source.

Since this is a dually, I'd suspect the rear differential. After 16 years of towing and hauling it's not unusual for the rear end to go bad.

Kruck88 Enthusiast

Kruck88

Posted
  • Author
Posted
3 hours ago, davester said:

Maybe chock the front wheels and using the engine to spin the rear wheels.  If you know it has an open diff and not a G80, you might also chock one rear wheel and then other other and see if it happens on one particular side (If you have a G80, this is dangerous, as when the relative speed difference makes the G80 lock, then the chocked wheel will suddenly really want to spin).

I already tried that and couldn't replicate the sound.

Kruck88 Enthusiast

Kruck88

Posted
  • Author
Posted
1 hour ago, David89GMC said:

Did you clean the tires of all debris and check them for roundness? I often get what you describe and it's always a rock stuck in the tread, front or rear. Radial ply tires can fail with this symptom.

A clunk on each revolution indicates a wheel or axle related problem. The propeller shaft turns 4 times the speed of the wheels and final drive, so you can disregard that as a source.

Since this is a dually, I'd suspect the rear differential. After 16 years of towing and hauling it's not unusual for the rear end to go bad.

I have not checked for roundness but I would expect to feel something like that on the hwy.  I too am leery that it may be diff related.  What confuses me is that turning doesn't seem to change it and neither does throttle.  

  • 2 weeks later...
Kruck88 Enthusiast

Kruck88

Posted
  • Author
Posted

I did some more investigating today trying to figure this out.  It seems to come and go so I drove the truck on the road a while came home and jacked the axle off the ground and ran the truck.  I didn't hear the noise but let it keep running.  When I hear the clunk on the road it sounds like it's in sync with the revolution of the tires.  While the truck was idleing in gear on the jack stands suddenly I heard it... a loud THUNK.  After another 5 seconds or so it did it again.  Sounded like it was coming from the transfer case.  I cycled the transfer case through it's ranges, ran the truck in reverse, back forward, and even up through the gears and never heard the noise come back.  One thing I did notice is that if I got on the brake pretty hard after running it up to about 50 mph on the jack stands the tires would stop, then a loud thump from under the truck.  I am assuming the T-case is chain driven so it sounded and felt almost like there was a lot of slop in that chain.  

  • 1 month later...
Mark Allen Enthusiast

Mark Allen

Posted
Posted

I spoke with my transmission rebuilder about this common issue. He explained that many GM/Chev truck customers describe a slight clunking noise that often occurs during acceleration from a stop or near complete stop. There is teflon grease that is coated on the splines of the driveshaft yoke that slips into the rear of the transmission. When the transmission fluid and filter are serviced, he recommends always removing the driveshaft with the yoke from the tail shaft of the transmission and re-coating the splines of the yoke with the teflon spline grease. He said GM doesn't offer this spline grease, but Ford offers it. He said that it is common for the teflon grease to dry out and dissipate over time and miles, causing a clunking noise that sounds as though it were coming from the rear differential. The teflon spline grease cushions the contact and connection between the driveshaft yoke splines and the transmission tailshaft splines.

Black02Silverado Senior Enthusiast

Black02Silverado

Posted
Posted

This sounds like the same issue I had with my 2002 1500 Silverado.  GM fixed it with a new updated nickle plated slip yoke.  Took care of the clunk.  Seeing this is on a 3500 I would guess that it is a completely different yoke for sure, but might want to check and see if there was an updated one for yours as well.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined

  • Who's Online   1 Member, 0 Anonymous, 1,647 Guests (See full list)

  • Latest Articles

  • Posts

    • Coastie05
      Replacing 2.7L on 2021 Silverado with 2023 2.7L

      By Coastie05 · Posted

      I’m definitely interested to hear the end result here. 
    • MASONV88888888
      Another 6.2L engine failure!

      By MASONV88888888 · Posted

      My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • MASONV88888888
      Rattle in the rear!

      By MASONV88888888 · Posted

      Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • Buckwild27
      Gas Prices

      By Buckwild27 · Posted

      I have 2 choices. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...