Allison Fluid?

By ABQFirefighter
February 15, 2005 in Gen III & Gen IV V8 Engines (LS-Based)

Recommended Posts

ABQFirefighter

Posted February 15, 2005

Anybody recommend a good Allison fluid other than the Transynd? Thanks for the info.

Shotgun

Posted February 15, 2005

I reccomend amsoil but you can use any dextron III fluid.

ABQFirefighter

Posted February 15, 2005

Author

Posted February 15, 2005

Thanks shotgun.

I went with a Dexron III rated sythetic blend a couple of months ago. I didn't change out all the fluid, just drained from the pan plug and added the new blend to the existing dino fluid. I haven't towed yet with it, but during my daily driving empty, the tranny temps seem to be a bit lower.

GOOSE

Posted February 15, 2005

Here's something to look at: Synthetic ATF

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

Recently Browsing 0 members
- No registered users viewing this page.
Forum Statistics

250.3k
Total Topics

2.7m
Total Posts
Member Statistics

342,686
Total Members

8,960
Most Online

Newest Member
Victorlani
Joined 3 hours ago
Who's Online 1 Member, 1 Anonymous, 335 Guests (See full list)
- davester

Latest Articles
- GM Recalls 2,700+ Trucks For Airbags That Can Explode While Parked – How To Check Your VIN
  Wednesday at 07:54 PM
- You Can Completely Disable A New Chevy Traverse By Bending The Rear Wiper Arm (No, Seriously)
  Wednesday at 05:47 PM
- Should You Use Engine Fuel Additives In Chevy or GMC? Here’s GM’s Official Statement.
  Wednesday at 02:38 PM
- We’ve Driven the Edition 1 For 4 Years. Here’s Why the Mid-Size HUMMER X Concept is Exactly What GMC Needs.
  May 29
Posts
- Oil Consumption
  
  By riddler · Posted 2 hours ago
  
  Over engineering everything LOL
- Oil Consumption
  
  By Grumpy Bear · Posted 2 hours ago
  
  Then you're saying the motor is full cold on the lowest mark of the sticks range. So,... you intentionally short your oil change a full quart? 😬 Yikes!! 😱 Every motor I've ever changed oil in over 64 years of oil changing that level has been at the top when the book amount of oil is put in and level checked by the OEM procedure. Kind'a the point of the top of the range. A double check if you will. Have any idea how much of a motors oil is not in the pan at peak pump volume? (second stage at red line). Depends on the motor but 2 quarts isn't out of the question. This one quart range got started when pans held 3-1/2 - 4 quarts. With 1.5 - 2 quarts circulating a motor 1 quart low would, could and often did spin a bearing as the pump suction became uncovered. Air is a pour lubricant. That low mark told the dummy operating it he was a tea spoon away for pulling the pin on that grenade. We have a bit more cushion today with much larger pans, windage trays and such, but we also have more oil in circulation and rings that are not as adept at oil control and some truly strange pan venting systems that will suck a pan dry enough to be trouble pretty quick if not in good repair. Give an automatic transmission stick a good look (If you can find a trans with a stick). They are clearly marked for both a cold range and a hot range and many like the JATCO's even have a table in the book showing level V temperature by degrees and voltage and mm on the stick. Even my 6L80E is setup that way. Engine Oil pan sticks are legacy one quart markers to keep Joey Bumpstick's motor in play.
- Oil Consumption
  
  By riddler · Posted 3 hours ago
  
  Humm! Homer, if you read what I actually wrote, you might gain understanding. SMH.....
- Bakflip refuses to sell the weakest, easily replaceable rubber hinge of their tonneau cover? What are my options?
  
  By Victorlani · Posted 3 hours ago
  
  I repaired my BaKflip MX4 hinge. I found a broken Tonneau on Facebook . A guy sold it for $40. I was able to remove the hinge on that. One of the hinge is also tripped but I still have 3 hinges left and I used the hinge closest to the cab. It took me 2 minutes to remove the hinge. It was not attached with any glue. It simply slides out. Undoing the seal on the side is the hardest part and it just slides back in. I don’t understand the liability excuse. There is no reason why they cannot replace the hinge. Now it’s perfect again. I was able to replace the latch as well using the part on the broken one. I got lucky!!!!
- Oil Consumption
  
  By Homer1959 · Posted 3 hours ago
  
  From the owner manual Sierra hd 2025 6.6 gas how to check engine oil level : To get an accurate reading, park the vehicle on level ground. Check the engine oil level after the engine has been off for at least two hours. Checking the engine oil level on steep grades or too soon after engine shutoff can result in incorrect readings. Accuracy improves when checking a cold engine prior to starting. Remove the dipstick and check the level. So, according to you, Riddler, with the engine cold we should aim for the low mark on the dipstick, and the high mark when the engine is at operating temperature? So you’re saying the engine oil expands by a quart... humm... I guess that's something GM dont know
GM-Trucks.com Clubs
- Black Truck Club
  
  Open Club · 612 members
- White Truck Club
  
  Open Club · 380 members
- Canadian Owners Club
  
  Open Club · 282 members
- Red Truck Club
  
  Open Club · 156 members
- diesel 3.0
  
  Open Club · 279 members
- Texas Owner's Group
  
  Open Club · 371 members
- NorthSky Blue Club
  
  Open Club · 118 members
- Midwest Owner's Group
  
  Open Club · 212 members
- 2015 Custom Sport Club
  
  Open Club · 5 members
- GM Snow Plowing Club HD
  
  Closed Club · 14 members
Popular Contributors
- Week
- Month
- Year
- All Time
1. 1
  
  KARNUT
  35
2. 2
  
  Atlas
  25
3. 3
  
  Grumpy Bear
  12
4. 4
  
  riddler
  7
5. 5
  
  Chuck FB
  7
Show More