Jump to content

Need Some One Has 07 Yukon Denali


Recommended Posts

Posted

hi

 

My 07 yukon Denali is now in for its sixth major service repair. One of the major issues is the symptom of depressing the gas to modestly accelerate and the engine RPM's ACTUALLY DECREASE!!!! Yes, pressing on the gas causes the engine to slow down. You can hear the motor bog and see the tach drop about 300 to 400 RPM's. To make this TURD move you absolutely have to STOMP on the gas and hope the transmission finds the right gear. My transmission will upshift and downshift rapidly searching for a correct gear to use. Meanwhile, nothing is happening in the speed department.

 

and all i get get from dealler "your vehicle is operating within normal parameters"

 

what about yours ?

Posted

Not mine.

 

Only complaints are the 2 to 3 shift, where it feels like it falls on it's face

 

A-Post wind and wind noise

 

But the fly-by-wire go pedal is coupled to the "go" just fine, I can feather it at idle or cruise with no issues.

I must have one that is screwed up since it doesn't act like your's which is supposed to be the norm according to your dealer.

 

see another dealer

Posted

i dont have any problems with my 07 denali .. i do notice sometimes that the tranny shifts a little funny , but thats it

what other issues are you having

Posted
hi

 

My 07 yukon Denali is now in for its sixth major service repair. One of the major issues is the symptom of depressing the gas to modestly accelerate and the engine RPM's ACTUALLY DECREASE!!!! Yes, pressing on the gas causes the engine to slow down. You can hear the motor bog and see the tach drop about 300 to 400 RPM's. To make this TURD move you absolutely have to STOMP on the gas and hope the transmission finds the right gear. My transmission will upshift and downshift rapidly searching for a correct gear to use. Meanwhile, nothing is happening in the speed department.

 

and all i get get from dealler "your vehicle is operating within normal parameters"

 

what about yours ?

 

 

Skytop1?? Ha, Busted!!!!

Posted

I have an '07 Yukon Denali "shorty" version. I have never had the engine lose RPM when shifting while gas is depressed. It will ususally downshift instantly to a lower gear to get the rpm's up and then it takes off like a rocket. The only wierd thing I have noticed is when the truck is first started in the morning, once and a while it will read "low fuel". Ten minutes later it will be back to reading normal, half tank left, etc...

 

The driver's side wiper blade clicks against the windshield when in use. What I did was take it off and used a mill file to remove some of the plastic tab on the end of the wiper. Still looks stock and no clicking anymore.

 

The driver's door has a very quiet but annoying rattle to it, can't figure it out yet so I just turn to music up. Broke 10K on it last week while on vacation and have had no problems with it. Knock on wood.

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • What’s missing in all this is patience and investment in the future. Buy a 170K starter home. Ten years later sell it invest in a more expensive home. Eventually you’ll have a 600K home and pay starter home payments. Buy a starter car. Maintain it well. Save the payments after it’s payed for then buy an expensive car if you desire. Buy a tumbler make your own coffee, pack your lunch. Cook your own dinner. Most importantly take care of your car.
    • People mislead themselves. Statistics are highly useful indicators.   Here's the tie-in to this thread. If an oil sample tests shows a wear indicator of 7 using cheaper ACDelco oil, and a wear indicator of 2 (lower = less wear) using a particular brand of Mobil oil, and wear has a linear relationship with engine lifespan, anyone could assume that Mobil is reducing wear by more than 50% (let's just say a 200% reduction for you red state people trying hard to do math) which leads to increasing engine life by 2x. Perhaps, in a vacuum, by itself, when dreamed by AI.   Yeah?! That's what the statistic is saying, isn't it?   No, it isn't. It didn't come out and say engine life is doubled. That's a very bad assumption, and a case of severe myopia by assuming something potentially untrue about the only data point in focus.   Average cost of a new car is 50k. You bet it is.   The median cost of a new car is more like 35k. Expensive cars are skewing the perception that "average" now means a $50k price of entry for a very average automobile. And that's not true. People who don't understand statistics twist the living heck out of them to mean all sorts of things they don't actually mean.   "Average" new car payment is $1000/month. Yep, it is. And in that number are all the $35k new car buyers who bring significant equity, and the $25k new car buyers who finance the car for a month just to get a rebate, and then pay it off. Know what isn't in that number? All the payments made by people who don't finance a car.   Picking one's own data point (don't have a car payment, never paid $50k for a new vehicle, my house cost $170k, I afforded a middle class lifestyle on $4.50/hr) is just a data point. Just like earning $25/hr in an area where the median home price is almost $1 Million is a data point. In fact, it's a lot of data points given that 80% of the US population lives in/around major cities. They're not idiots; the vast majority of them do it to make a living because that's where the big money is.   The highs have become higher, lows have become lower, and how your personal mileage varies is not truth for an entire country. At the same time you can't NOT acknowledge the data. While it doesn't paint YOUR personal picture, it certainly tints the reality that you also live in, as does your single data point.    
    • Glad you had success with it. I did as well, but about 5-6 months later it returned. Tried again, same result. This was after the dealer made several attempts and never even got it to slow down.
    • 3.15 Kroger’s in Montgomery Tx
    • I have a LTZ and it has the shifter in the console, which I like, but, every now and then, it will not stay in Reverse. I go through all the motions, hold the button in, push the shifter forward and watch the dash.  The big red R comes on and also the back up camera.  Then, it just pops out of Reverse with the shifter all the way forward.  So then the game begins.  Back and to Drive, Reverse.  This goes on 8 - 10 times. Very frustrating. Had it back to the dealer and they replaced some kind of computer, but it is now happing again. It is so bad, my wife will not drive the truck, she is afraid of being stuck somewhere.    Anyone else with this PIA problem? 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...