vonrokker

That is seriously NICE!

I did the exact same setup on my 2019 LTZ 4wd. I confirmed with the company that the lift blocks where flat (not tampered) and that I needed to leave the factory shims in place. Everything went in just fine and I love the look now. I have a 2.5" eibach lift in the front and now a 1.5" block in the rear. I measured out at the front of 40" and the rear is 40.5" so just a little rake.

How did you make the connection to the 7-pin connector for power/ground?

any idea who?

awesome thanks, Did you have any trouble compressing the eibach springs using the spring compressor?

How did you compress the springs to remove the perch from the old struts and how was it to compress the new springs?

Still for sell?

Hey Ryan, Those calipers look good. What paint did you use? Did you put any clear coat over the red? Thanks Aaron

Great thanks for the info.

Has anyone installed the RC 2" leveling strut on their 19-20 trucks? I have an Z71 LTZ with Rancho's up front and they suck! Wondering if this would be an easy upgrade for somewhat better struts. I bounce down the road after hitting any kind of bump. I am not looking to spend lots of money and was not looking to put much bigger tires on. Just a little lift but better ride is all I want.

I am doing my panels right now in Matte Red Metallic. How did you get the line between the chrome and the panel so nice. I am having a hard time getting it cut and rolled down into the separation. What tools are you using?

How hard was it to form around the radio console?

Thanks, ordering some now!

That is freaking awesome, what color is that and where did you get it from?

What 2" block did you use? Can you measure the front now you have the Eibach's installed?